Intended Use - Oregon MINIGRINDER 590181 Manual De Instrucciones

using exclusively OEM spare parts, otherwise whoever uses the
machine could be in serious danger.
- Use a proper electric tool.

INTENDED USE

This machine is an electrical grinder for chains used in chain saws.
- Use the machine exclusively for the types of chains stated in the
technical data chart.
- Do not use the machine to cut or grind anything other than the
chains envisaged.
SYMBOLS
This symbol points out the possibility of serious personal
injuries if the provisions and instructions are not complied
with.
This symbol points out that the user must wear protection
goggles when he uses the machine.
PART DESCRIPTION (FIG. iv)
1. Depth adjustment knob
2. Grinding wheel, 3/16"
3. Front protection
4. Large washer
5. Flange nut
6. Shield guard screw
7. Knob
Note: for spare sarts, see fig. vi.
- insert the screw into the slot (photo 3).
- position the rear protection (photo 4A).
- secure the handle on the screw (photo 4B).
- position the wheel guard properly (foto 6A - 6B), by rotating it till the notch hits the arm (foto 6C) and secure it with the position lock
screw (foto 6D).
8. Vise assembly
9. Dressing brick
10. Template
11. Handle bolt
12. Operating handle
13. Rear protection
- Do not use low effective tools for heavy duty applications.
- The machine must not be used in corrosive or explosive
environments.
- Any other use is to be considered improper.
The manufacturer is not liable for damages following improper or
incorrect use of the machine.
This symbol points out that the user must wear protective
gloves when he uses the machine.
This symbol points out the correct running direction of the
machine (grinding wheel)
230 Volt
13