EHEIM professionel 3- 250 Instrucciones De Uso página 15

The connecting line of this device can not be replaced. In case of damage to the power cord, the device is to be
scrapped. Never carry the pump by the cable; do not bend the cable.
This equipment is not intended for use by persons (including children) with limited physical, sensory or mental abili-
ties or for persons with no experience or knowledge unless they are supervised by a person responsible for safety or
unless they have received from such a person instructions on how to use the equipment. Children should be supervised
to ensure that they do not play with the equipment.
Notice: These devices produce magnetic fields which might cause electronic and mechanical disturbances or
20 cm
damages. This also refers to pacemakers. Please consult the manuals of medical equipment for the re-
quired safety margins.
Attention: Maintenance work presents the risk of crushing th fingers due to high magnetic forces.
For your own safety, we recommend to form a drip loop with the connection cable to prevent any
water running along the cable from intruding into the socket. When using a multiple socket or an
external power supply unit, position them atop the filter's power connection.
Since a wide variety of varnishes and polishes are used when processing timer, the appliance feet
can leave visible traces on furniture or parquet floors as a result of chemical reactions. Therefore
the device should not be placed on unprotected wooden surfaces.
To achieve optimal operational safety there must be a maximum of 180 cm between the surface of
the water and the bottom of the filter.
Attention: Filter must always be operated in an uprigt position only.
Burning danger! Be careful when touching the heating coil of devices with integrated heater.
Take the necessary precautions when handling components that can discharge static electricity.
Do not clean the unit – or parts of it – in the dishwater. Not dishwater resistant!
Do not dispose of this product as normal household waste. Take it to your local refuse collection side.
The product is qualified in accordance with the respective national regulations and guidelines and meets
EC standards.
2. Component overview (see II)
1. Filter mat blue 2. Prefilter seal 3. Prefilter 4. Prefilter flap 5. Cover grating 6. Filter pad white 7. Filter
inserts 8. Rubber buffers 9. Locking clips 10. Filter tank 11. Hose locking device 12. Locking lever 13. Safety
adapter 14. Bracket 15. Float 16. Suction aid 17. Pump head 18. Adapter bar 19. Control panel (profes-
e
sionel 3 ) 20. Profile seal 21. Pump wheel 22. Pump cover 23. Hoses 24. Outlet elbow 25. Nozzle pipe
26. Suction pipe 27. Sucker with terminal clamp 28. Power supply unit (only in professionel 3
2074) 29. Suction basket 30. Power cable 31. Connector socket for EHEIM Interface (optional)
3. Connection and commissioning
1. Set the locking lever (12) to „OFF" and press the adapter bar (18) until the safety adapter (13) disengages.
2. Open the locking clips (9) by pulling the clips' lower edge. 3. Remove the pump head (17). 4. Remove all
inserts. Caution: Do not overfill filter inserts as, otherwise, their accurate fit is no longer assured. 5. Fill the
filter inserts with EHEIM filter media. 6. Rinse the filled filter inserts with water.
Note: Easier cleaning with EASY CLEAN function.
7. Close the filled filter cartridge with the screened cover (5). 8. Shake the filter cartridge under running water.
Repeat this procedure with all filter cartridges. Caution: insert the white filter fleece into the very top filter car-
tridge and close it with the screened cover. 9. Then, re-insert the filter cartridges in the following sequence into
the filter container (10): In professionel 3 - 250 (Type 2071): 1. Filter cartridge with EHEIM MECH pro. 2. Filter
cartridge with EHEIM SUBSTRAT pro, white filter fleece and screened cover (see III).
7
max.
180 cm
e
- 350 Type