Aux Function - Clarion DXZ835MP Manual De Instrucciones

Operations Common to Each Mode
Anti-theft indicator
The red Anti-theft indicator is a function for pre-
venting theft. When the DCP is removed from
the unit, this indicator blinks.
∗ The factory default setting is "OFF".
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button and select
"BLINK LED".
3. Turn the [ROTARY] knob clockwise to set
this function "ON" or turn it counterclockwise
to switch this function "OFF".
4. Press the [T] button to return to the previous
mode.
Setting the Subwoofer
∗ The factory default setting is "SUB-W ON".
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button and select
"SUB-WOOFER".
3. Turn the [ROTARY] knob clockwise or coun-
terclockwise and select "ON" or "OFF".
4. Press the [T] button to return to the previous
mode.
Setting LOW PASS FILTER
∗ The factory default setting is "THRGH".
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button to select
"SUB-W LPF".
3. Turn the [ROTARY] knob clockwise or coun-
terclockwise to select the setting. Each time
you turn the [ROTARY] knob, the setting
changes in the following order:
THRGH ➜ LPF 50 ➜ LPF 80 ➜ LPF 120
4. Press the [T] button to return to the previous
mode.

AUX function

This system has an external input jack so you
can listen to sounds and music from external
devices connected to this unit.
22
DXZ835MP
Selecting AUX IN sensitivity
Make the following settings to select the sensi-
tivity when sounds from external devices con-
nected to this unit are difficult to hear even after
adjusting the volume.
∗ The factory default setting is "MID".
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button to select "AUX
SENS".
3. Turn the [ROTARY] knob clockwise or coun-
terclockwise as needed and select from
"HIGH", "MID" or "LOW".
4. Press the [T] button to return to the previous
mode.
Triggered audio mute for cellular
telepones
This unit requires special wiring to mute the au-
dio signal automatically when a cellular tele-
phone rings in the car.
∗ This function is not compatible with all cellular
telepones Contact your local authorized Clarion
dealer for information on proper installation and
compatibility.
Setting the clock
1. Press and hold the [T] button for 1 second or
longer to switch to the adjustment selection
display.
2. Press the [a] or [d] button to select
"CLOCK".
3. Press the [ ] button.
4. Press the [a] or [d] button to select the
hour or the minute.
5. Turn the [ROTARY] knob clockwise or coun-
terclockwise to set the correct time.
∗ The clock is displayed in 12-hour format.
6. Press the [ ] button to store the time into
memory.
7. Press the [T] button to return to the previous
mode.
Note:
• You cannot set the clock when it is displayed with
only the ignition on. If you drain or remove the
car's battery or take out this unit, the clock is re-
set. While setting the clock, if another button or
operation is selected, the clock set mode is
canceled.