Master (Software Fader); Show Day Scheduler; Manually Starting A Show - Oase WECS II 512 DMX/02 Instrucciones De Uso

- GB -
21

Master (Software fader)

Use the four arrow keys
functions provide direct access to the 6 submasters, including the grandmaster. You can set the level for
each master directly and make several settings for each master. These settings include maximum values
of 100 % to minimum values of 0 % By means of the WEPS software, all faders can be connected to
component control channels. For instance, this makes it possible to dim the brightness of the LEDs by
means of one of the masters.
Up to three Windmasters can be configured. Each Windmaster's curve can be changed by means of three
interpolation support points on its linear characteristic curve. The speed for fading-up and fading-down
can be configured separately. (Ramp Up, Ramp Down). Furthermore, a waiting time can be set as idle
time before fading-up the Windmaster. (Waitig Time Up).
22

Show day scheduler

Use the four arrow buttons
1. Scheduler The show day scheduler, week scheduler and year scheduler can only be changed by
means of the WEPS software. The show day scheduler is always activated with each restart. To deactivate
it, use the system menu
23

Manually starting a show

Use the four arrow buttons
Once the show scheduler has been disabled (see item 16 Show day scheduler) a show can be started
manually by accessing
software from the SD card.. Use
40
to get from the main level to the sub-menu item
to get from the main level to the sub menu item
Enable Scheduler Off (Disabled).
to get from the main level
Run Show and selecting a showfile .wds
Stop Show to stop the show again.
7.Master
2.Show to the sub menu item
created by means of the WEPS
. The master
Run Show .