Switching On The Unit - Oase InScenio EGC Controller Instrucciones De Uso

Switching on the unit

Establishing a connection to the WLAN router via WPS
WPS (WIFI Protected Setup) is a standard for establishing a WLAN connection at the
touch of a button.
• It is not necessary to enter the network name (SSID) and password.
• The WLAN router must support WPS.
Prerequisite:
• The range of the WLAN connection between the WLAN router and InScenio EGC
Controller can span a distance of up to 80 m provided there is unobstructed signal
transmission and there are no sources of interference.
• Compatibility with the WLAN standard 802.11n+g and only in the frequency range
2.4 GHz.
How to proceed:
1. Press the WPS key on the WLAN router to activate WPS.
– WPS is only active for a limited time. Activate WPS on the InScenio EGC Control-
ler during this time.
– Please also note the information in the operating manual of the WLAN router.
2. Briefly press the WPS key on the InScenio EGC Controller (max. 2 seconds) to acti-
vate WPS.
– The LED rapidly flashes green.
– The WPS remains active for 2 minutes.
 The connection is established when the LED begins to flash green slowly (2 seconds
on, 1 second off).
EN
EGC0008
23