CAME SPOTIX Manual De Usuario página 13

OPERATION:
AUTO MODE
Press the MODE button repeatedly until "AUTO MODE" appears on the
display. In this mode, there is an automatic switch between colour change,
meteor, colour fading and flow effect. The speed of the program is
adjustable separately and a stroboscope effect can also be activated.
Press the MODE button until "AUTO" appears in the upper line of the display.
Now, press ENTER until the cursor appears in the lower line of the display,
and then using the UP and DOWN buttons, select the rate (SPEED) for the
sequence from 00 to 99.
Confirm with ENTER. The indicator in the bottom line of the display changes
to "FLASH:xx". The cursor will appear in the bottom line at the same time and
you can activate the stroboscope effect using the UP and DOWN buttons and
adjust the strobe frequency from 00 to 99 (FLASH:00 = strobe deactivated,
FLASH:01 = approx. 1 Hz, FLASH:99 = approx. 20 Hz). Confirm with ENTER.
SLAVE MODE
Press the MODE button repeatedly until "SLAVE MODE" appears on the
display. Connect the slave and the master unit (same series) with a DMX
cable. Now the slave unit follows the master unit.
MUSIC CONTROL (SOUND)
Press the MODE button until "SOUND" appears in the upper line of the
display. Now the projector is controlled by the built-in microphone and
follows the beat of the music. To adjust the microphone sensitivity, press
ENTER, and the cursor appears in the lower line of the display (SENS:xx)
and use the UP and DOWN buttons to set the desired value from 00 to 99
(SENS:00 = minimum sensitivity, SENS:99 = maximum sensitivity). Confirm
with ENTER.
SELECT DMX MODE
Press the MODE button repeatedly until "DMX MODE" appears in the upper
line of the display. Press ENTER, and the cursor appears in the lower line of
the display and then use the UP and DOWN buttons to select one of the six
DMX modes (02CH, 03CH1, 03CH2, 04CH, 06CH, 12CH/21CH). Confirm with
ENTER. You will find tables with the channels of the different DMX modes on
the following pages of this manual.
DMX START ADDRESS
Press the MODE button repeatedly until "DMX ADDR" appears in the upper
line of the display.. Press ENTER, and the cursor appears in the lower line
of the display and then use the UP and DOWN buttons to select the desired
DMX start address between 001 and 512. Confirm with ENTER.
13