Image Surface Adjustment - Sony VPLL-3003 Manual De Instrucciones

Image surface adjustment

When the image surface adjustment screw is turned, the
image surface can be adjusted.
The image surface adjustment screw is set at the ceiling
surface of the projection lens when the projector is on
the floor or suspended. The image surface adjustment
screw is set at the side of the projection lens when the
projector is set at the portrait orientation.
Image surface
adjustment screw
1
Turn the image surface adjustment fixing screw to
the left and loosen it.
The image surface adjustment fixing screw is
positioned at the opposite side of the image surface
adjustment screw.
2
Adjust the focus at the projected surface near the
projector.
3
Confirm the image surface further from the
projector.
4
When the image surface is in front of the projected
surface, turn the image surface adjustment screw to
the left. When the image surface is at the further
back of the projected surface, turn the image
surface adjustment screw to the right. Then, adjust
the focus further from the projector.
28
Adjusting
Image surface adjustment
fixing screw
Image surface adjustment screw (top)
Turning to the right
Image surface adjustment screw (side)
Turning to the right
Screen
Image surface
5
Repeat 2 to 4 so that the image surface matches the
projected surface.
6
When the adjustment is finished, turn the image
surface adjustment fixing screw to the right and
tighten the screw until it is fixed.
Turning to the left
Turning to the left