Components Required For Operation; Intended Use; Operating Principle; Preparation And Setup - Aesculap Suhl Favorita II Instrucciones De Manejo

Aesculap Suhl GmbH
Shearing machine Favorita II, Favorita Speed, Electra® II, Ehmann turbo-line®

2.2 Components required for operation

• Shearing machine Favorita II, Favorita Speed, Elec-
tra® II, Ehmann turbo-line®
• Shearing head

2.3 Intended use

Note
The device is intended exclusively for cutting animal
hair.
The shearing machine Favorita II, Favorita Speed, Elec-
tra® II, Ehmann turbo-line® is used for shearing small
animals.
The device is used with a shearing head to be selected
according to the respective application.

2.4 Operating principle

The device is switched on (off) by pushing the ON/OFF
switch up (down).
4
3.

Preparation and setup

Non-compliance with these rules will result in com-
plete exclusion of liability on the part of Aesculap.
Always observe the following guidelines when set-
ting up and operating the product:
– national regulations for installation and opera-
tion,
– national regulations on fire and explosion protec-
tion.
– operating advisories according to IEC-/VDE regu-
lations.
Fire and explosion hazard!
Do not operate the product in
explosion-hazard areas.
DANGER
Malfunction of, or damage to the
product caused by improper setup!
Do not expose the product to
direct sunlight or moisture.
CAUTION
Do not cover the ventilation
slots of the product.
Connect the product to the
specified voltage of 100 V to
240 V/50 Hz to 60 Hz.
Ensure that the mains power
socket used for supplying the
product is freely accessible.