Sanyo CE42WPX1 Manual De Instrucciones página 12

GB
Specification
Common specification
Power source 220~240V 50Hz
Television system System I
Colour system PAL / NTSC3.58 (in AV mode),SECAM
Channel coverage UHF: 21-69,
VHF: E2-E12,F2-F10,R1-R12
CATV: X, Y, S1 -S41, B-Q
Aerial input impedance 75 ohm
AV terminal
AV1: CENELEC Standard
Input: Composite video, RGB (5V RGB with 5V sync to
pin 14) and audio-L/R
Output: TV-output with composite video and audio-L/R
AV2: CENELEC Standard
Input: Composite video, S-VHS and audio-L/R
Output: Monitor-output with composite video and
audio-L/R
Audio Monitor.Out: CINCH L/R
Audio Speaker out: 2 x 6W
HDMI Input: HDMI group Standard
PC Input: 15-pin D-Sub type
Contrast Ratio 1500:1
Screen(inches/ cm) 42" / 107 cm
(viewing measured diagonally)
Display Native Resolution 1366 X 768 (WXGA)
Viewing angles H:178°, V:178°
Dimensions (WxHxDmm) 1027x620x167.5
Weight (kg) 35.5
MODEL : CE42WPX1
523.01
546
620
Viewing Area(V)
12
SPECIFICA
SPECIFICA
B/G, D/K, L'L
989
921.5
1027
953
930.25
Viewing Area(H)
296.5
402.9
417.9
TIONS / HELPFUL
TIONS / HELPFUL
■ NO PICTURE,
● Check if the monitor is plugged in.
● Try a different channel, if OK, probably station trouble.
● Check monitor is not in standyby mode.
■ POOR PICTURE
● Adjust BRIGHTNESS control.
● Adjust FINE TUNING control.
● Check aerial connections.
■ NO COLOUR, PICTURE OK
● Adjust COLOUR control.
● Adjust FINE TUNING control.
● Does the programme/ signal have colour ?
● Check lead connections.
■ WEAK PICTURE
● Check aerial connections on back of set.
● Check aerial for broken wires.
● Re-orientate aerial.
■ REMOTE CONTROL DOES NOT WORK
● Check batteries are inserted correctly
● Check condition of batteries
● Check to see if remote control inhibit is set ON
The following faults are not caused by the receiver:
"GHOSTS"
Reflections of signals from mountains or high buildings will cause
multiple images, called "Ghosts". These abnormal conditions can be
reduced to a minimum by repositioning the aerial or by installing a
new one suited for your area.
"INTERFERENCE"
Interference may be caused by electrical appliances, car ignition
systems, etc. This should normally be a temporary condition, but
should this interference persist, contact your dealer.
167.5
164.5
130.5
51.5
303
φ 4.2
162.9
(LED INDICATOR)
φ 7.62
(RC RECEIVER)
HINTS
HINTS
Helpful hints
418.4
190
200
300
GB
(Wall mount screw)
4ｘM6, 1.0 pitch X 12 mm
418.4
28.8
200