Black and Decker PRO BB600 Manual De Instrucciones página 10

ENGLISH
other condition that may affect the power tools operation. If damaged, have the power tool repaired
before use. Many accidents are caused by poorly maintained power tools.
f. Use the tool in accordance with these instructions and in the manner intended for the particular type
of power tool, taking into account the working conditions and the work to be performed. Use of the
power tool for operations different from those intended could result in a hazardous situation.
5. Service
a. Have your power tool serviced by a qualified repair person using only identical replacement parts.
This will ensure that the safety of the power tool is maintained.
6. Labels on tool
The label on your tool may include the following symbols:
Read Instructions Manual
Use Eye Protection
Use Ear Protection
Electrical safety
This tool is double insulated; therefore no earth wire is required. Always check that the power
supply corresponds to the voltage on the rating plate.
WARNING: If the supply cord is damaged, it must be replaced by the manufacturer, an authorized Black & Decker Serv-
ice Centre or an equally qualified person in order to avoid a hazard. If the supply cord is replaced by an equally qualified per-
son, but not authorized by Black & Decker, the warranty will lose effect.
ADDITIONAL SAFETY INSTRUCTIONS FOR BLOWERS
• Do not collect still smoldering cigarette ashes, freshly cut metals shaving, screws, nails and the like.
• Never block suction inlet and outlet.
FEATURES
This tool includes some or all of the following features.
1. Nozzle
2. Blast Port
3. Trigger Switch
4. Variable Speed Knob
ASSEMBLY
WARNING: Before assembly, make sure that the tool is switched off and unplugged.
USE
MOUNTING THE NOZZLE FOR BLOWING OPERATIONS (FIG. A)
• Insert the pin located inside the Nozzle into the notch provided on the Blast Port (1).
• To lock Nozzle in place, turn the Nozzle in the direction indicated.
• To remove Nozzle, turn the Nozzle in the opposite direction.
MOUNTING THE NOZZLE AND DUST FOR DUST COLLECTION (FIG. B)
• For dust collection, mount the Dust Bag at the Blast Port (2) and Nozzle at the Suction Port (6).
• To remove Dust Bag and Nozzle, simply pull out by first turning in the opposite direction.
• Empty the Dust Bag frequently to ensure maximum dust collecting efficiency.
OPERATING THE BLOWER (FIG. C)
• To switch your Blower on, depress the Switch (3). To stop your Blower, release Switch.
• Adjust Variable Speed Knob (4) for different speed requirement.
V ........... Volts
A ........... Amperes
Hz ......... Hertz
W........... Watts
min........ minutes
........ Alternating Current
5. Lock-On Button
6. Suction Port
7. Dust Bag
10
........ Direct Current
n .......... No-Load Speed
0
........ Class II Construction
........ Earthing Terminal
........ Safety Alert Symbol
.../min.... Revolutions or Reciprocation
per minute