Attaching The Ferrite Core - Insignia NS-H3005 Guia Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Connecting devices to your home theater
system
To connect devices to your home theater
system:
Connect the LINE 1 or LINE 2 jacks on the
home theater system to the AUDIO/VIDEO
OUT jacks on your accessory component
using the optional audio/video cables.
Accessory device jack panel
Back of home theater system
Connecting the radio antennas to your
home theater system
Connect the supplied AM and FM antennas so
you can listen to the radio.
To connect the radio antennas:
1 Connect the AM loop antenna to the AM
antenna connector.
2 Connect the FM wire antenna to the FM
antenna connector.
10
Accessory component such as a VCR,
camcorder, video camera, satellite
receiver, or laser disc player
AUDIO
OUTPUT
R
L
VIDEO
OUTPUT
OR
Front of home theater system
AM loop antenna
FM wire antenna
www.insignia-products.com
Insignia NS-H3005 Home Theater System
Note
• To prevent noise pickup, keep the AM loop antenna away
from the home theater system and other devices.
• Be sure to fully extend the FM wire antenna.
• After connecting the FM wire antenna, keep it as close to
horizontal as possible.
Connecting speakers to your home theater
system
Connect the speakers using the supplied
speaker cables.
To obtain the best possible surround sound,
adjust the speaker distance and level settings.
For more information, see "Speaker Setup" on
page 17.
Front speaker
Center speaker
(right)
Rear speaker (right)
Note
• Make sure that you match the speaker cable to the
appropriate terminal on the connectors: + to + and – to –. If
the cables are reversed, the sound is distorted and lacks
bass.
• When making the sound louder, adjust the sound level
carefully to avoid excessive volume output to the speakers.
• Only 2-channel stereo (Front Left, Front Right, and
Subwoofer) is available in VCR mode. Sound might not be
heard from center or rear speakers during VCR playback.
(For further details about sound mode, see "Sound mode"
on page 6.)
• Do not remove the front covers of the speakers.

Attaching the ferrite core

Be sure to attach the ferrite core to the speaker
cables. The ferrite core reduces unwanted
noises.
To attach the ferrite core:
1 Open the ferrite core by pressing the stopper.
2 Wind the cable once around the ferrite core.
Front speaker
(left)
Rear speaker
Subwoofer
(left)
Stopper

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido