IKRA HLSI 250 Instrucciones De Manejo página 19

• Do not start the tool when it is upside down or when it
is not in the operating position
• Switch the motor off and remove the plug when the
tool is not being used, left unattended, being cleaned,
being moved from one place to another or when the
extension cord is entangled or damaged.
• Do not operate the tool near people, especially chil-
dren or pets. Turn it off if they get too close. Maintain
a safe distance of at least 5m from other people when
using the tool.
• Never direct the blower tube towards bystanders or
pets. Never blow debris in the direction of bystanders
or pets. The operator is responsible for accidents or
hazards occurring to other people or their property.
• Do not handle the plug or the tool with wet hands and
do not use the tool in the rain.
• Use only outdoor rated extension leads that are so
marked. Keep the extension cord away from heat, oil
and sharp edges.
• Ensure that the extension lead is secured in a manner
that prevents it form disconnecting from the plug whilst
in use.
• Keep all the air intakes and the blower tube free of
dust, lint, hair and other material that may cause a
reduction in air flow.
• Keep a balanced and stable stance while using the
tool.
• Do not switch on the tool in enclosed or poorly ven-
tilated spaces or in the presence of inflammable and
/or explosive substance such as liquids, gases and
powders.
• Do not get distracted and always concentrated on what
you are doing. Use common sense. Never operate the
tool when you are tired, sick or under the influence of
alcohol or other drugs.
• Do not operate this appliance with long loose hair or
loose fitting jewellery. Tie long loose hair back and
remove loose fitting jewellery.
• Do not allow the blower vac to pick up any burning or
smoldering materials like ashes, cigarette butts etc.
• Do not attempt to pick up breakable objects like glass,
plastics,china etc.
• Do not use in vacuum operation without the collection
bag fitted
• Do not use the blower vac in either the vacuum or the
blower position on gravel surfaces.
• Only operate the tool during broad daylight or with
adequate artificial light.
• When the tool is not in use, store it in a dry place and
out of reach of children.
• After use ,disconnect the tool from the power supply
and check for damage. If you have the slightest doubts
, contract an authorized service centre.
• Only use the tool according to the instructions given in
this manual.
• Check regularly that screws are tight.
• Use only spare parts and accessories recommended
by the manufacture.
• Do not try to repair the tool or access internal parts.
Contract authorized service centers only
GB-4