Safety Instructions; Setup And Operation - Pontec PONDOSTAR 20 Instrucciones De Uso

GB

Safety Instructions

Electrical connection
- For your own safety, please contact an electrical specialist for questions and
problems!
- Electrical installations for garden ponds and swimming pools must correspond to
the national construction determinations.
- The safety transformer must be supplied via a residual current protective fixture (FI
switch or RCD) with a measured current of not more than 30 mA.
- The halogen spotlight may only be operated with the supplied safety transformer
in accordance with VDE 0551 IEC-742 / EN 60742.
- Electrical data of the supply power and that specified on the nameplate on the
safety transformer must agree.
- The installed bulb wattage may not exceed the transformer power according to the
nameplate.
- The transformer is designed for outdoor use in an ambient temperature between -
10°C to + 35°C. Do not expose the transformer to direct sunlight.
- The halogen spotlight is designed for use in pond water in a temperature range
between +4°C to +35°C.
- Do not operate the halogen spotlight if the connecting cable, the safety transformer
or the pond light appear defective!
- Keep the connecting points dry!
- Do not carry or pull the halogen spotlight or the safety transformer by the power
cords!
- Never open the casing of the halogen spotlight if there are not specific instructions
in this regard in the operating instructions.
- The halogen spotlight is designed exclusively for operation with 12V low
voltage. Life-threatening danger exists when connecting to 230 V.

Setup and operation

- Always unplug the power plugs of all devices located in the pond and of the halogen
spotlight before working on the garden spotlight and pond spotlight!
- The transformer must have at least 2 m clearance to the edge of the pond. Position
the transformer where it cannot be flooded!
8
Directions for use
GB