On/Off Switch - Weed Eater WT3100 Manual De Instrucciones

NOTE: When performing the following step,
besure t he starter rope i snot caught under
the cable clamps. The starter rope must
hang f reely tooperate properly,
Cable
clam_
-<
Starte_
Throttle
cable
7. Align one cable clamp above the tube bolts
and the other below the starter rope han-
dle. Install the cable clamps one at a time
around the tube and throttle cable.
NOTE: Ensure throttle cable is in groove of
clamps and lies flat against the upper handle
tube after h_stallation (see illustration above).
KNOW YOUR TRIMMER
READTHIS INSTRUCTION MANUAL AND SAFETY RULESBEFORE OPERATING YOUR UNIT
Compare the illustrations with your unit to familiarize yourself with the location of the various controls
and adjustments. Save this manual for future reference.
Throttle Trigger
Starter Rope
Handle
I
/
Upper Handle
/
Lower Handle
ON/OFF
Switch
Choke Lever
Primer Bulb Muffler
Shield
ON/OFF SWITCH
The ON/OFF switch is used to stop engine, To
stop the engine, move the switch to the OFF
position,
PRIMER BULB
The PRIMER BULB removes air from the car-
buretor and fueI lines and fills them with fuel.
This allows you to start the engine with fewer
pulls on the starter rope. Activate the primer
bulb by pressing it and allowing it to return to
its original form.
Head
CHOKE
The CHOKE helps to supply fuel to the engine
to aid in cold starting. Activate the choke by
moving the choke iever to the FULL CHOKE
position. After the engine attempts to start, move
the choke lever to the HALF CHOKE position.
Once engine has started, move the choke lever
to the OFF CHOKE position.