3 | Safety
3.1 | Intended use
This PTFE friction-reducing foil is attached between the handlebar tube and the throttle twistgrip,
and thus reduces the friction on the throttle twistgrip. No lubricant is required in this position.
The reapplication of grease is no longer necessary. It can be used for metric (Ø 22 mm), imperial
(Ø 25.4 mm) and double-butted (Ø 28.6 mm) handlebars.
3.2 | Safety instructions
WARNING!
Risk of accident!
• After attaching the PTFE friction-reducing foil, the throttle twistgrip must be
properly attached to the vehicle again.
• The throttle twistgrip must turn freely and snap back into the initial position
when released.
• Before each journey, check whether you throttle twistgrip moves freely.
WARNING!
Danger for children and persons with reduced physical, sensory or mental
abilities (e.g. partially disabled persons, elderly persons with reduced physical
and mental abilities) or lack of experience and knowledge (e.g. older children)!
• Keep the PTFE friction-reducing foil and the packaging out of the reach of
children under eight years old. There is a risk of suffocation if swallowed!
CAUTION!
Risk of injury!
• To avoid injury when removing/installing the throttle twistgrip, make sure that
your vehicle cannot topple over and that the workstation is well lit.
• Only install the PTFE friction-reducing foil/throttle twistgrip yourself if you have
the necessary technical knowledge. Otherwise, the job must be carried out by a
motorcycle workshop.
10
This symbol gives you useful additional information about assembly or
usage.
This symbol indicates that the packaging and product can be recycled.