THROTTLE TUBE
1 | Scope of delivery
Order no. 10019635 - for imperial (diam. 25.4 mm) handlebars
1
Order no. 10041380 - for metric (diam. 22 mm) / double-butted (diam. 28.6 mm) handlebars
1
1
Throttle Tube
2
Throttle cable adapter I
12
3
Throttle cable adapter II
3
Instructions (not shown)
4
2 | General information
2.1 | Reading and keeping the instructions for use
These instructions for use apply exclusively to the specified throttle tubes. They
contain important information on installation, safety and warranty. You should
read these instructions carefully, in particular the safety instructions, before
installing a throttle tube. Failure to follow these instructions can lead to serious
injury or damage to the motorcycle. Keep these instructions for future reference.
If you pass the throttle tube on to a third party, you must also hand over these
instructions.
The installation instructions are based on the standards and regulations
applicable in the European Union and reflect the current state of technology. If
abroad, you should also observe country-specific guidelines and laws.
2.2 | Explanation of symbols
The following symbols and signal words are used in these instructions.
WARNING!
CAUTION!
2
IMPORTANT!
3 | Safety
3.1 | Intended use
The throttle tubes are suitable for numerous motorcycles with either an imperial
(diam. 25.4 mm), metric (diam. 22 mm) or double-butted (diam. 28.6 mm)
handlebar. They can be used to install aftermarket grips or to replace a defective
This symbol/signal word indicates a hazard with a
medium risk level which, if not avoided, may result
in death or serious injury.
This symbol/signal word indicates a hazard with
a low risk level which, if not avoided, may result in
minor or moderate injury.
This signal word warns of possible material
damage.
This symbol gives you useful additional information
about assembly or usage.
This symbol indicates that the packaging and
product can be recycled.
13