Note On Inner Liner In Gas-Cooled Welding Torches; Installing The Inner Liner In The Torch Hosepack - Fronius MTG 400i K4 Manual De Instrucciones

Note on inner lin-
er in gas-cooled
welding torches
Risk due to incorrect wire-guide insert.
This can result in poor-quality weld properties.
► If a plastic inner liner with a bronze wire-guide insert is used in gas-cooled welding
► In order to operate gas-cooled welding torches at maximum power, replace the 40 mm
1
1
Installing the in-
ner liner in the
torch hosepack
So that the inner liner can be correctly installed, lay the hosepack out straight when
installing the inner liner.
1
1
36
NOTE!
torches instead of a steel inner liner, the power data stated in the technical data must
be reduced by 30%.
(1.575 in.) wire-guide insert with a 300 mm (11.81 in.) wire-guide insert.
NOTE!
2
2
2
2