No Signal Menu; Table 8. No Signal Menu - Hitachi CP-S225W Manual De Usuario

O P E R A T I O
O P E R A T I

No Signal Menu

The same adjustments and settings are available with the Image and
Options menus when the MENU button is pressed during display of the
"NO INPUT IS DETECTED ON ***" or "SYNC IS OUT OF RANGE
ON ***" message while no signal is received.

Table 8. No Signal Menu

Item
Volume Adjustment: Reduce VOLUME
• When this function is used, audio input is automatically switched to video. The
VOLUME
audio input can be switched by moving the DISK PAD left and right during the
display of the volume adjustment bar. The volume adjustment bar is displayed by
pressing VOLUME
Select Blank Screen Color: Select the color with the
•The image is cleared and the entire screen is displayed in the selected color,
BLANK
when BLANK mode is set with BLANK ON, or when there is no signal for 5
minutes.
Operation Start/Stop: Press the
MIRROR
Select Mirror Status: Select the mirror status with the
Operation Start/Stop: Press the
Setup Initial Screen Display: Select the TURN ON with the
START UP
Clear Initial Screen Display: Select the TURN OFF with the
• Note that if TURN OFF is selected the blank screen is displayed in blue when there is no signal.
MENU COLOR Select Menu Background Color: Select the color with the
Operation Start/Stop: Press the
LANGUAGE
Select Menu Display Language: Select the language with the
buttons.
Operation start/stop: Press the
Set AUTO OFF: Set 1~99 minutes with the
system automatically enters the standby mode when a signal is not
AUTO OFF
received for the set time.
Clear AUTO OFF: Select the STOP (0 min.) with the
the STOP is selected the system does not enter the standby mode even
if no signal is received.
Operation Start/Stop: Press the
SYNC ON G Valid: Select the TURN ON with the
SYNC ON G Invalid: Select the TURN OFF with the
SYNC ON G
• May not be displayed correctly with some input signals when the SYNC ON G is
valid. In such cases, remove the signal connector so that no signal is received,
set the SYNC ON G to invalid, and reconnect the signal.
Operation Start/Stop: Press the
Set/Clear Wisper Mode: Press
WHISPER
selected, the WHISPER mode is active. In the WHISPER mode,
acoustic noise level from the unit is reduced, brightness level on screen
is a little lower.
N S ( c o n
O N S ( c o n
Description
or VOLUME
t i n u e d )
t i n u e d )
VOLUME
BLANK
MIRROR
START UP
MENU COLOR
LANGUAGE
AUTO OFF
SYNC ON G
WHISPER
↔
Increase VOLUME
button.
and
/ button.
and
/ button.
/ button.
/ button.
and buttons. The
/ button.
button.
button.
/ button.
/ button. When the WHISPER is
16
buttons.
buttons.
button.
button.
and buttons.
and
button. When
ENGLISH-15