Troubleshooting/ Repairs - Quipall 2000EPW Manual De Instrucciones

7. Troubleshooting
Symptom
The machine will not
start
Fluctuating pressure
The machine stops
Fuse blown
Pulsing machine
The machine turns on
and off by itself
The machine is on
but no water comes
out
Cause
The machine is not plugged-in
Faulty receptacle
The fuse has blown
Faulty extension cable
The pump is drawing in air
Valves dirty, worn or sticking
The water supply is not
sufficient
Pump seals worn
The fuse has blown
Incorrect mains voltage
Thermal sensor activated
Partially blocked jet
Fuse too small
Increase in the amperage
Air in inlet hose / pump
Inadequate supply of water
generated
Partially blocked jet
Water filter blocked
Folded pipe
Pump fuse and/or trigger out of
order
No water supply
Water filter blocked
Blocked jet
Recommended action
Plug the machine in
Try another receptacle
Replace the fuse Unplug other appliances
Try without the extension cable
Check that hoses and connections are airtight.
Contact your service center
Increase water pressure, check for blockages
and / or change the large pipe.
Contact your nearest service center
Replace the fuse
Unplug other appliances
Check that the mains voltage corresponds to the
specifications on the nameplate
Leave the machine to cool for 5 minutes
Clean the jet with a needle and by spraying
water rearward through the jet
Replace it with a fuse with higher amp
consumption than the washer.
Try without the extension cable
Allow machine to run with open trigger until
regular working pressure resumes.
Increase water pressure, check for blockages
and / or change the large pipe.
Clean the jet with a needle and then spray water
backwards through the jet
Clean the filter
Unfold the pipe
Contact your nearest service center
Connect the inflow water.
Clean the filter
Clean the jet with a needle and by spraying
water rearward through the jet
10