2. First time instructions
This section will explain in detail how to
prepare this Electric Pressure Washer
for first time use
SAFETY DEVICES
The unload valve can reduce pressure if
it exceeds pre-set values.
Locking device on trigger gun (see
illustration at the beginning of this manual):
The trigger gun features a locking device.
When the knob is activated, the trigger gun
cannot be operated.
THERMAL SENSOR
A thermal sensor protects the motor against
overloading. The machine will restart after
a few minutes when the thermal sensor has
cooled.
3. Operation instructions
3.1 Connection of garden hose
Screw the water inlet coupling (3) tight on
to the water inlet Note: The inlet filter (A)
must always be fitted in the water inlet pipe
to filter out sand, lime stone and other
impurities as these will damage the pump
valves.
Caution: Failure to fit the filter will
invalidate the guarantee.
Connect the garden hose with a standard
garden connector (18).
.
3.2 Mounting of high pressure hose
Attach the high pressure hose to the trigger
gun and machine.
Detach the high pressure hose by pressing
the pawl (A) or button (B)
3.3 Mounting of lance and nozzle
Push the lance into the trigger gun
When inserted turn it. Caution: Make sure
the lance is properly fixed to the gun
Attach the nozzles. Caution: When
attaching the nozzle, the button (A) on the
nozzle should come out again. Check before
activating the trigger that the nozzle is
properly fixed.
6
A
B
GB