Publicidad
MEASURE AND MARK
12
THE REAR BRACKETS.
With the rear brackets
in place measure
and set them equal
distance from the front
brackets, then mark
the forward-most
holes with a marker.
13
DRILL THE HOLES.
15
SET THE BRACKETS TO BE PARALLEL.
Measure the distance between the two brackets at the
ends with the rivets (Y) then pivot the brackets to set
the other end of the brackets to that same distance (X).
Instruction #1035971B - Page 5 of 15
Drill a pilot hole with the
1/8" drill bit where you made
the mark.
Lubrication may be helpful.
Then use the 3/16" drill bit to
drill the hole to 3/16".
Repeat the process on the
other side of the vehicle
starting with the forward-
most hole.
Carefully blow or brush aside
the swarf (metal debris)
on each side to prevent
scratching the paint.
X = Y
X
Y
14
CREATE A PIVOT POINT.
Put the rear brackets in place
and insert a rivet through each
of the forward-most holes of the
brackets and through the holes
you drilled in the previous step.
Do not flare
rivets yet!
2X
16
MARK THE REAR HOLES.
Without moving the brackets
mark the center and rear holes.
2X
2X
4X
Publicidad
