Specifications - Schumacher PID-760 Manual Del Usuario

PROBLEM
Inverter does not
turn on.
Device does
not operate
properly when first
connected to the
inverter.

11. SPECIFICATIONS

Maximum Continuous Power ................................................................ 760 Watts
Surge Capability (Peak Power) ........................................................... 1520 Watts
No Load Current Draw .................................................................................<0.6A
Wave Form ........................................................................... Modified Sine Wave
Input Voltage Range ................................................................... 10.5V-15.5V DC
Output Voltage Range .................................................................... 120V±5% AC
Low Battery Alarm ............................................................. Audible, 11V±0.3V DC
Low Battery Shutdown .................................................................10.5V±0.3V DC
High Battery Shutdown ................................................................15.0V±0.5V DC
Optimum Efficiency ......................................................................................>85%
AC Outlet ........................................................................... Two, NEMA 5-15 USA
USB Port ....................................................................................One, 5V 2.0 Amp
Dimensions .........................................................................8.5" L x 4" W x 2.2" H
Weight ................................................................................ approximately 3.5 lbs.
POSSIBLE CAUSE
Poor contact at terminals
Fuse is blown.
The inverter may not have
the required capacity to
operate the device.
Check for poor connection to
battery or power supply. Make
sure connection points are clean.
Rock clamps back and forth for a
better connection.
A blown fuse is usually caused by
reverse polarity or a short circuit
within the inverter. To replace,
contact a qualified service
technician who will diagnose
the problem and replace the
fuse(s) with the appropriate
replacement(s).
Turn the inverter switch OFF and
ON, to reset the inverter.
• 12 •
REASON/SOLUTION