Fenton SBS30 Serie Manual De Instrucciones página 6

Ocultar thumbs Ver también para SBS30 Serie:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

If the number of songs on the disc/USB drive is more than 99, the 10th digit of LED display will show letter A to F (A=10, b=11,
C=12, d=13, E=14 & F=15). For example, if it contains "118" songs, "b8" will show on the LED display. If the number of songs
on the disc/USB flash drive is over 159, the LED display will show 99. However, if you have connected to a TV, full disc content
information will be shown. All basic play/pause, stop and skip controls are identical to CD mode.
5.
Select your favorite song using the NEXT/PREV button.
6.
Tap PLAY/PAUSE button to start playing.
7.
Turn ON your microphone and starting singing. Adjust the MASTER VOLUME, MIC VOLUME and TV VOLUME if
necessary.
Important Hints on playing CDs
CD mechanisms used in devices like this are designed to fully read all commercial CDs. They will also read self-
compiled CD-R/CD-RW discs but it may take up to 10 seconds for playback to start. If playback does not start, it is
likely due to the quality of the CD-R/CD-RW disc and/or the compatibility of the CD compilation software. Manufacturer
is not responsible for the playback quality of CD-R/ CD-RW discs.
Do not apply excessive force or press the CD door while it is playing.
Never place anything except a compact disc in the disc compartment. Foreign objects can damage the unit.
Only load one disc into the disc compartment at a time.
Singing along from Aux Input Sources
This karaoke unit features an aux-in jack for connecting your iPod, MP3 player or other digital music player.
1.
Connect the headphone jack of your external device to the AUX IN jack located on the lower side of this unit (The
connection cable is not included).
2.
Turn on the unit player and it will enter the AUX function mode once an external device is plugged into the AUX IN
jack.
3.
Connect the line out or headphone jack of your external audio device (e.g. a CD player, MP3 player, iPhone, iPod,
etc...) to the unit with a suitable audio cable (not included).
4.
Select your favorite song on your external audio device to play. You may need to adjust the output volume of your
external audio device if the headphone jack is used for making the connection.
5.
Turn on your microphone and start singing. Adjust the MASTER VOLUME and/or MIC VOLUME if necessary.
6.
You may also use the BALANCE and ECHO controls to enhance your singing experience. Turn off both devices after
use.
NOTE: Once the AUX IN jack has been plugged into, the unit automatically enters the AUX mode no matter what position the
Function Selector is in. Remember to disconnect the Aux In cable from the unit after use in order to listen to the CD or USB
input again.
Using the Unit as a Public Address System
This unit can also be used as a PA (Public Address System).
NOTE: To prevent feedback or whistling from occurring, please be sure that the microphone is not held too close to unit's
speaker.
1.
With unit stopped at CD or USB mode, unplug any 3.5mm audio cable (not included) connected to the AUX IN JACK
previously.
2.
Turn on your microphone (one included) and start your performance. Adjust the MASTER VOLUME, MIC VOLUME
and ECHO control if necessary.
LED Light Show
The LED light shows inside the speaker and in the lower corners of the unit are created automatically based on the
music source being played at the time
Set Light Show control to "ON" to turn ON the LED show.
Set Light Show control to "OFF" to turn LED show OFF.
6

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

130.170130.172

Tabla de contenido