Button Functions - Clatronic KA 3642 Instrucciones De Servicio

Notes on Use
Placement
• Place the automatic coffee maker on a stable and level
surface. Place the appliance in such way that it cannot
tip over.
• Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.
European Regulations on Energy Saving
NOTE:
The European Directive 2009/125/EC (Ecodesign Directive)
incorporates measurements for energy saving.
The following applies to coffee makers: The keep-warm
period is limited to max. 40 minutes after which the appli-
ance turns off automatically.
You benefit from better safety and lower energy consump-
tion.
Electric Connection
1. Ensure that your mains power corresponds with the
specifications of the appliance. The specifications are
printed on the type label.
2. Connect the mains cable to a properly installed and
earthed wall outlet.
Initial Operation
Before making coffee for the first time operate the appliance
twice with clean water only and without paper filter. This
removes dust, which may have collected during transport.
Follow the instructions given under "Switching on the Coffee
Machine Directly".

Button Functions

ON / OFF
Pressing once: Turn on the device, the pilot lamp RUN
lights, immediate brewing process;
Pressing twice: TIMER mode, the pilot lamp AUTO
lights, brewing process will start at the
programmed time;
Pressing 3 times: Turning off device.
PROG
Pressing once: Setting of the current time;
Pressing twice: Adjustment of the start time; query of the
adjusted start time.
HOUR
Hour
MIN Minute
Operation
Set the time
The device works in the 24-hour mode. The time "12:00" is
preset.
32
KA 3642_IM
Press the PROG button one time. "CLOCK" will appear
above the time in the display.
• Set hours:
Press the HOUR button.
• Set minutes:
Press the MIN button.
• Leaving the setting mode:
Wait ca. 15 seconds after the last push of a button.
"CLOCK" in the display goes out.
Preparing the Coffee Machine
1. Open the lid of the water tank.
2. Fill cold water according to the desired amount of cups
of coffee into the rear water tank. The water level is
displayed on the indicator.
NOTE:
You can use the pot to fill the water tank.
CAUTION:
Do not overfill the tank! Do not fill it above the MAX
mark.
3. Ensure that the filter holder is properly attached.
4. Turn over the lower fold of the paper filter (size 1x4) and
place it in the filter funnel. Then fill it with coffee powder.
5. Now close the lid of the water tank.
6. Place the jug onto the warming plate.
CAUTION: Drip stop
Your appliance comes with a drip stop. It closes when
removing the coffee pot. This prevents the coffee from
dripping onto the warming plate if there is still water in
the filter.
• Ensure that the lid is attached to the coffee pot. It
opens the drip stop.
• If there is still water in the tank, place the pot under-
neath as soon as possible. Otherwise the filter might
overflow.
Switching on the Coffee Machine Directly:
Please follow the instructions under points "Preparing the
Coffee Machine".
7. Press the ON / OFF button once. The pilot lamp RUN
lights. The appliance is operational.
NOTE:
• The unit switches off automatically about 40 minutes
after the brewing. The ON / OFF button indicator
lamp turns off.
• If you yourself would like to shut off the device
beforehand, press the ON / OFF button twice. The
pilot lamp RUN goes out.
Automatic Operation:
Please follow the instructions under points "Preparing the
Coffee Machine".
14.03.16