Operation; De-Scaling; Cleaning - Proficook PC-KA 1121 Instrucciones De Servicio

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 20

Operation

1. Open the lid of the water tank.
2. Fill cold water according to the desired amount of cups
of coffee into the rear water tank. You can determine the
water level with the help of the scale in the water tank.
NOTE:
You can use the pot to fill the water tank.
CAUTION:
Do not overfill the tank! Do not fill it above the MAX mark.
3. Ensure that the filter holder is properly attached.
4. Turn over the lower fold of the paper filter (size 1 x 2) and
place it in the filter funnel. Then fill it with coffee powder.
NOTE:
Do not put too much coffee powder into the filter to
avoid spillage.
5. Now close the lid of the water tank.
6. Place the jug onto the warming plate.
CAUTION: Drip stop
Your appliance comes with a drip stop. It closes when
removing the coffee pot. This prevents the coffee from
dripping onto the warming plate if there is still water in
the filter.
• Ensure that the lid is attached to the coffee pot. It
opens the drip stop.
• If there is still water in the tank, place the pot under-
neath as soon as possible. Otherwise the filter might
overflow.
7. Switch on the device. The operating control lamp lights up.
NOTE:
The unit switches off automatically about 30 minutes after
the brewing. The operating control lamp turns off.
If you want to use the appliance again, you have to switch it
off first by setting the switch to " ". Following that, proceed
as described in "Operating".
WARNING:
• Before cleaning, always remove the mains plug and wait until the
device has cooled down.
• Do not immerse the device in water. Otherwise this might result in
an electric shock or fire.
34
PC-KA 1121_IM
The Coffee is Ready
• When no more coffee is flowing through the filter you can
remove the pot.
• Turn the device off.
• Would you like to keep the remaining coffee warm? Leave
the appliance turned on until the end of the keep-warm
period. If you wish to keep the coffee warm even after the
keep-warm period has finished, pour the remaining coffee
into a thermal flask.
NOTE:
The filter holder can be removed from the machine by its
handle.
This makes it easier to dispose of the old coffee filter, for
example.
WARNING:
If you want to make another pot of coffee immediately,
switch off the device first. Let it cool down with the water
tank open in order to avoid hot water splashing when
refilling with water.
De-scaling is necessary when the brewing time increases
substantially.
• Use only commercially available citrus acid-based
de-scaler.
• Follow the recommended instructions for use.
WARNING:
• Afterwards you should boil fresh water in the pot
three or four times in order to rinse out residues of the
de-scaling agent.
• Do not use any coffee powder!
• Do not use this water for consumption.

Cleaning

De-scaling

20.01.17

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido