Unpacking The Appliance; Overview Of The Components / Delivery Scope; Notes On Use; Placement - Proficook PC-KA 1120 Instrucciones De Servicio

It is not intended for use in farm accommodation or Bed & Break-
fast establishments.

Unpacking the Appliance

1. Remove the appliance from its packaging.
2. Remove all packaging materials such as films, filler
material, cable clips and carton.
3. Check the contents for completeness.
4. In the event that the packaging content should be incom-
plete or if damages are noticeable, do not operate the
appliance. Return it to the dealer immediately.
NOTE:
Production residue or dust may have collected on the appli-
ance. We recommend cleaning the appliance according to
chapter "Cleaning".

Overview of the Components / Delivery Scope

1 Filter holder
2 Water tank lid
3 Tab to open the water tank lid
4 Water tank
5 Water level indicator
6 Warming plate
7 Glass jug with lid
8 Function buttons
ON / OFF Turn appliance on and off
HOUR
Hour
MIN Minute
MODE Set current time
Program TIMER operation
9 Display

Notes on Use

Placement

• Place the automatic coffee maker on a stable and level
surface. Place the appliance in such way that it cannot
tip over.
• Do not place the appliance in close proximity to a gas or
electric stove or any other heat source.

European Regulations on Energy Saving

NOTE:
The European Directive 2009 / 125 / EC (Ecodesign Direc-
tive) incorporates measurements for energy saving.
The following applies to coffee makers: The keep-warm pe-
riod is limited to max. 40 minutes after which the appliance
turns off automatically.
You benefit from better safety and lower energy consump-
tion.
PC-KA1120_IM

Electric Connection

1. Ensure that your mains power corresponds with the
specifications of the appliance. The specifications are
printed on the type label.
2. Connect the mains cable to a properly installed and
earthed wall outlet.

Initial Operation

Before making coffee for the first time operate the appliance
twice with clean water only and without paper filter. This
removes dust, which may have collected during transport.
Follow the instructions given under "Switching on the Coffee
Machine Directly".

Button Functions

ON /OFF
Pressing once: Turn on the device, immediate brewing
process (The button lights up blue.)
TIMER mode, brewing process will start
Pressing twice:
at the programmed time (The button lights
up green.)
Pressing 3 times: Turning off device. (The button indicator
lamp turns off.)
MODE
Pressing once: Setting of the current time;
Pressing twice: Adjustment of the start time; query of the
adjusted start time.
HOUR Hour
MIN Minute

Operation

Set the time

The device works in the 24-hour mode. The time "12:00" is
preset.
Press the MODE button one time. "CLOCK" will appear
above the time in the display.
• Set hours:
Press the HOUR button.
• Set minutes:
Press the MIN button.
• Leaving the setting mode:
Wait ca. 15 seconds after the last push of a button.
"CLOCK" in the display goes out.

Preparing the Coffee Machine

1. Open the lid of the water tank.
2. Fill cold water according to the desired amount of cups
of coffee into the rear water tank. The water level is
displayed on the indicator.
37
23.09.16