Ur6D System Settings - Samson SYNTH SIX Manual Del Propietário

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE: The procedures described below are the same for the model UR6DX receiver.
Setting The Receiver Group/Channel
1. Press the RX1 or RX2 button to select the receiver whose Group or Channel setting you wish to
change. The level meter numbers of the selected receiver will blink for about three seconds.
2. Press the appropriate Up/Down Value button to change the Group and/or Channel setting
(the Up button will step through the Groups and Channels incrementally; the Down button will
step through them decrementally). Be sure to select the same Group and Channel as that set for the
transmitter.
3. To check and make sure that the receiver Group/Channel matches that of the transmitter, set the
transmitter's Power On-Off switch to its "On" position. The corresponding receiver's RF Level meters
should appear and its Mute Indicator should not be lit.
Changing the Display Panel Contents
1. Press the RX1 or RX2 button to select the receiver whose display contents you wish to change.
The level meter numbers of the selected receiver will blink for about three seconds.
2. Press the Display button repeatedly to change the display contents in the following sequence:
Frequency (of the selected Group/Channel) -> Title 1 -> Title 2.
Inputting Titles
1. Press the RX1 or RX2 button to select the receiver whose Title (name) you wish to change.
The level meter numbers of the selected receiver will blink for about three seconds.
2. Press the Display button one or more times until the Title you wish to change is shown in the display
panel.
3. Press the Title button in order to enter Title Input Mode. A cursor will flash at the first character of
the Title and the Title Indicator will light.
4. Use the Value Up/Down buttons to input characters and the Title button to move the cursor one
character to the right until you input all characters. Note that pressing any front panel controls except
the Value Up/Down and Title buttons during Title Input Mode cause the title to be invalidated.
The following characters are available:
↑ ↓ ! " # $ % & ` ( ) * + , - . / 0 1 2 3 4 5 6 7 8 9 : ; < = > ? @
A B C D E F G H I J K L M N O P Q R S T U V W X Y Z [ ψ ] ^ _
a b c d e f g h i j k l m n o p q r s t u v w x y z { | } → ← ο  
5. To complete the procedure and exit Title Input Mode, move the cursor to the eighth (rightmost)
character and press the Title button. This causes the Title Indicator to turn off.
Checking Current Rear Panel Settings
1. Press the Status button one or more times to change the display contents in the following sequence:
Channels (normal display) -> Antenna Attenuation -> Output Level -> Output Mixing

UR6D System Settings

.
\
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Ur6d

Tabla de contenido