Troubleshooting - SOLAC AE2550 Instrucciones De Uso

AE2550.book Page 19 Thursday, November 14, 2013 5:37 PM
6 Replace the cover (24) and fasten screw (23) to secure it.
CLEANING THE APPLIANCE
Z
Clean the appliance before using it for the first time, immediately after each use, and after a
long period without use. This will ensure the correct operation of the appliance and prolong its
useful life.
p
Make sure that no water enters the appliance.
1 Clean the outside of the appliance with a damp cloth. Do not use abrasive products or solvents.
2 Regularly check that the wheels at the back of the unit are clean.
RECYCLING
Z
When you decide to discard the device, first remove the battery.
1 Unplug the device and allow it to operate until the battery is completely flat, then take it to an
Authorised Technical Service.
Z
The batteries used in this appliance are LITHIUM batteries, they must therefore be recycled or
disposed of according to local laws and regulations. NEVER throw batteries in containers for
household rubbish. Deposit the appliance in a suitable container.
q
IMPORTANT! When you want to dispose of the appliance, NEVER throw it in the
rubbish bin. Take it to the recycling or waste collection centre closest to your home
for processing. You will be helping to care for the environment.
LIMITED WARRANTY
i
This product is guaranteed for 2 years from the date of sale against all manufacturing or
material defects, including labour and spare parts, or replacement of the appliance unless
one of these options is impossible or disproportionate.
The guarantee will be void in the following cases:
• If the corresponding invoice, receipt or delivery note is not presented or its data has been
manipulated.
• If it has been used for professional uses or not exclusively for domestic use.
• If the appliance has been disassembled or manipulated by third parties not authorised by SOLAC
as official Service Technicians.
• The guarantee does not cover wear due to the normal use of the product.
• If the fault has been caused by knocks, falls or the use of harmful, chemical, obstructive or corrosive
products.
• If the fault has been produced by unsuitable maintenance or a lack of cleaning.
• Is the appliance has been connected to a voltage other than that indicated on the specifications
label.
• If the appliance has been used incorrectly and not in accordance with the instructions.

TROUBLESHOOTING

If your vacuum cleaner is not functioning properly before making any checks, slide the switch on/
off switch to the off position (O)
Problem Cause
Your vacuum does The unit is not charged
not start
Your vacuum starts The charger cable is
but switches off after connected
a few seconds
RECYCLING
Solution
Recharge the batteries
_Unplug the charger cable from the
unit
_Follow the operating instructions
en
19