SOLAC AE2550 Instrucciones De Uso página 20

AE2550.book Page 20 Thursday, November 14, 2013 5:37 PM
The indicator does Badly connected cable to
not light when unit or mains
charging
Mains socket not working
The vacuum does The suction nozzle or tube
not suck (10) is partially blocked
The filter assembly (15) is
blocked
Dirt on the multi-purpose
brush (22) is preventing it
from rotating
The motor for the multi-
purpose brush (22) has
overheated due to tangled
waste
The vacuum has lost The suction nozzle or tube
suction power, is (10) is partially blocked
noisier or whistles
The dust container (11) is
full
The dust container (11) is
not fitted correctly
The suction head (20) is
dirty
The foam motor protection
filter (16) is saturated
The vacuum is Suction power too high
difficult to move
Rear wheels are dirty
20
Connect the cable correctly to the unit
and the charger to the mains supply
Contact an electrician to have it
repaired
Remove the dirt blocking the suction
nozzle (C)
Follow the CLEANING &
MAINTENANCE instructions
Follow the CLEANING &
MAINTENANCE instructions
_Slide the On/Off switch to the O
position.
_Allow the unit to cool down
_Follow the instructions for cleaning
the multi-purpose brush described in
the CLEANING & MAINTENANCE
section
Remove the dirt blocking the suction
nozzle.
Empty it as described in CLEANING &
MAINTENANCE
Fit it correctly
Follow the CLEANING &
MAINTENANCE instructions
Follow the CLEANING &
MAINTENANCE instructions
Reduce the suction power
Clean the rear wheels
TROUBLESHOOTING