Troubleshooting; Ec Declaration Of Conformity - Rothenberger Industrial 1500000041 Instrucciones De Uso

TROUBLESHOOTING

Problem
Soldering iron does not
heat up.
The temperature of the
soldering tip is too low.
The solder does not run
smoothly on the solde-
ring iron.
This product was manufactured and tested with care. In the unlikely event of a fault the machine
must be repaired by an authorised customer service centre.
Product description / function:
Type / model identifier:
Serial number / Lot number:
Trade name:
Appropriate EC directives:
Applicable harmonised
standards:
Oliver Hahn
Purchasing Manager
and person responsible for
technical documentation
Possible cause
No power supply.
Mains cable or
plug damaged.
Soldering tip is loose.
The soldering tip is not
hot enough.
EC-Declaration of Conformity
We,
WALTER WERKZEUGE SALZBURG GmbH, Gewerbeparkstrasse 9, 5081 Anif, Austria
declare that the design and construction of the following appliance, in the form supplied by us,
comply with the basic health and safety requirements of the appropriate EC directives.
This declaration covers the appliance only in the condition in which it was supplied by us. It
does not cover parts subsequently fitted by the user or modifications made after purchase.
Soldering iron set
JY-060-08(30W)
11-201 – 2011-11
ROTHENBERGER INDUSTRIAL 30 W Soldering iron set
EC Machinery directive 2006/42/EG
EC Low voltage directive 2006/95/EEC
EC Directive on electromagnetic compatibility (EMC) 2004/108/EEC
EN 60335-2-45:2002+A1:2008; EN 60335-1:2002+A11:2004+A1:2004+A2:2006+A12:2006
+A13:2008; EN 62233:2008; EN 55014-1:2006; EN 55014-2:1997+A2:2008;
EN 6100-3-2:2006; EN 6100-3-3:2008; EN 50366:2003+A1:2006+A13:2008
Anif, 01-11-2011
Technical documentation is available from:
WALTER WERKZEUGE SALZBURG GmbH
Gewerbeparkstrasse 9, 5081 Anif-Austria
13
Troubleshooting
Check that the mains supply
(socket) functions correctly.
Ask a competent person for advice
if necessary.
Have the mains cable replaced
by the manufacturer or the
manufacturer's representative.
Disconnect the machine from the
mains. Allow the soldering iron to
cool down. Tighten the
soldering tip fixing screw.
Wait until the soldering iron is hot
enough.
Allow the machine
to cool down completely and
check whether the soldering tip
is loose.
Alexander Reischl
Product Manager