Battery Low Indication; First Use - Topcom BUTLER S100 Manual De Usuario

4 Battery low indication

When the batteries are low the LED's start to blink 3 times every 5 seconds. When the battery
are completely empty, the unit no longer carries out operations. We advise you to charge the
unit for 12 hrs so that it can be recharged completely.

5 First use

The Butler S100 is a visual ringing amplifier which can be used in large or noisy places. Or
used by people who has a hearing problem. When there is an incoming call the Butler S100
will flash and if the speaker is turned ON it will loudly ring. (With a sound level of 85dBA max.)
It can only work if you have already a DECT GAP base station/telephone!
The Butler S100 is a receiver only and the transmitter is the DECT telephone base station.
Before you can use it, it must be registered on the base.
6 Operation
6.1 Register to a base
Before you can register the Butler S100 on to a DECT base, the base station must be put in
registration mode and the system PIN code must be '0000' or '1111'. Also the base must
have one handset free to register. Please consult you base station/telephone manual how to
put it into registration/subscription mode and how to set the system pin code to '0000' or
'1111'!
• Make sure the Butler S100 is turned ON (see '6.2 Turning the unit ON or OFF').
• Put the base station into registration mode (see manual of your DECT base/telephone).
• Press and hold the tone key for 10 seconds.
• A beep will be heard when the speaker is turned ON and the LED will start to blink.
• During 1 minute the Butler S100 will search for a base which is in registration mode. If
it's found it will try to register with pin code = '0000' if it doesn't succeed it will try again
with pin code ='1111'.
• If it's registered the blinking will stop and a long confirmation beep will sound (if the
speaker is turned ON).
• If it's not registered there will be an error beep (two short beeps).
6.2 Turning the unit ON or OFF
To turn the unit ON, switch the ON/OFF key to the right.
To turn the unit OFF, switch the ON/OFF key to the left.
6.3 Incoming calls
When a call comes in, the unit LED's will flash and if the speaker is turned ON it will also ring.
It will stop when the other side of the line hangs up (base stops ringing) or when the line is
taken by one of the handset.
Topcom Butler S100
Topcom Butler S100
5