General Guidelines - HQ-Power VDLL60ST Manual Del Usuario

3.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

This device is designed for professional use on stage, in discos, theatres, etc. The VDLL60ST should
only be used indoors with the included power adapter connected to an alternating current of max.
230 VAC, 50 Hz.

Lighting effects are not designed for permanent operation: regular operation breaks will prolong their
lives.

Do not shake the device. Avoid brute force when installing or operating the device.

Select a location where the device is protected against extreme heat (see "Technical
Specifications"), dust and moisture. Respect a minimum distance of 0.5 m between the device's light
output and any illuminated surface.

Use an appropriate safety cable to fix the device (e.g. VDLSC7 or VDLSC8).

Familiarise yourself with the functions of the device before actually using it. Do not allow operation
by unqualified people. Any damage that may occur will most probably be due to unprofessional use
of the device.

Use the original packaging if the device is to be transported.

All modifications of the device are forbidden for safety reasons.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
4. Features

easy to use LED strobe

flash rate: 1 ~ 10 flashes/sec adjustable via sensitivity knob
5. Mounting

Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable
norms.

The carrying construction must be able to support 10 times the weight of the device for 1 hour
without deforming.

The installation must always be secured with a secondary attachment e.g. a safety cable.

Never stand directly below the device when it is being mounted, removed or serviced. Have a
qualified technician check the device once a year and once before you bring it into service.

Install the device in a location with few passers-by that is inaccessible to unauthorised persons.

Overhead mounting requires extensive experience: calculating workload limits, determining the
installation material to be used... Have the material and the device itself checked regularly. Do not
attempt to install the device yourself if you lack these qualifications as improper installation may
result in injuries.

Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.

Make sure there is no flammable material within a 0.5 m radius of the device.

Have a qualified electrician carry out the electric connection.

Connect the device to the mains with the power plug. Do not connect it to a dimming pack.

The installation has to be approved by an expert before the device is taken into service.
6. Operation
Switch the device on and off by means of the
adapter. Do not operate the device continuously.
Adjust the rate speed by turning the knob on the
backside of the device.
V. 02 – 27/05/2015
VDLL60ST
4 ©Velleman nv