Activation Of The Dual-Family Mode; Directions For Use; Using The Videophone - Extel ITOUCH SER.R1 Instrucciones De Uso

On/Off switch: this allows the impedance of the cable to be adjusted and is a great help in case of poor image
quality. To be set to ON or OFF depending on the quality of the video on the screen.
Each change in settings must be validated by the disconnection, during 30 seconds, of the adapter
f. Activation of the dual-family mode
See the wiring diagram (fig. 8)
- Change the position of the micro-switches on the intercom panel (switch 4 at off) and the monitors (switch 2 at
off = family 1, switch 2 at on = family 2) according to your installation.
must be validated by the disconnection, during 30 seconds, of the adapter
It is necessary to disconnect the power supply for at least 30 seconds in any cases when the product does not
work properly and particularly after :
- Adding a monitor
- Modifying the wiring
- Modifying the position of dip-switches on the back of a monitor
- 230 V~ power failures following a thunderstorm or works
SAFETY INSTRUCTIONS
The transformer must be mounted to a DIN rail in a modular fusebox or surface-mounted on a non-metal
surface using the two mounting holes. The terminal block covers must be fitted. The unit should be connected
to an electrical installation meeting applicable standards (NFC 15-100 for France) AFTER WIRING IS COM-
PLETELY FINISHED.
It is essential to ensure that the poles are correctly matched when connecting the handset.

DIRECTIONS FOR USE

6
Important: The touch keys must be handled by slightly touching with the fingers.
a. Using the videophone
• Pressing the button on the street unit triggers an audible alarm and switches on the monitor for approximately
30 seconds. When the visitor has been identified, press the
Note: The button only needs pressing once to communicate with the street unit.
For an installation with several monitors, only the main one (switch 3 OFF 4 OFF) displays the picture of the
visitor
• When the conversation is finished, wait for the end of the time-out (approximately 60s) or press the
to turn the monitor off.
- To prolong the image a further 30 seconds, press the
- If you have a second intercom panel or a surveillance camera as an option, press a second time on this key to
view them.
- If you press twice the key
second, the video of the main camera reappears.
- To control the strike plate or lock, press the
- To control the automatic opener, press the
Note that this function is only valid when the screen is switched on. The image disappears briefly
when the command is transmitted.
5GB
that the camera is not connected, you have a black screen and a noisy sound. After 1
key.
key.
CFI EXTEL ITOUCH SER.R1 - 05/2011 - V1
button to talk.
button.
button