Settings On The Roadside Panel(S); Switching Off The Ring Tone On The Monitor(S); Additional(S) Monitor(S) Mn Iron - Extel ITOUCH SER.R1 Instrucciones De Uso

For the visitor memory function, see chapter 7c, video
b. Settings on the roadside panel(s)
- If you notice that the camera lens is not correctly aligned when installing the monitor and the intercom panel in
their final positions, you can compensate for this misalignment when wiring by moving the camera horizontally and
vertically and/or turning the direction of the camera.
Caution, you can only compensate by a few centimetres in height.
- 2 settings are accessible in the roadside panel:
- On the upper left side, setting of the sound level for the speaker of the roadside panel.
- On the upper right side, setting of the sound level for the speaker of the monitor.
To change the settings, use a small screwdriver and turn it carefully without force to the abutments..
c. Visiophone settings
To access the visiophone settings menu, press the key.
•Video settings:
To access the video settings, press .
Turned on screen the key allows entering the menu and selecting the settings "Brightness contrast colour". Set
with the keys and
The potentiometer allows setting the sound level of the ring tones.
• Audio settings:
• Press to enter the ring tone mode selection
• The current ring tone is heard
• Scroll the ring tones by pressing the key .
• To fix the selected ring tone, press again the key .
d. Switching off the ring tone on the monitor(s)
• Press the key .
• The pictogram shifts from blue to violet.
• After a call, the face of the visitor will be displayed without ring tone (with the possibility to talk to him by press- After a call, the face of the visitor will be displayed without ring tone (with the possibility to talk to him by press-
ing the key ).
• To reactivate the ring tone, press the key .
• The pictogram shifts from violet to blue.
e. Additional(s) monitor(s) MN IRON
• The additional monitor connects with 2 wires to the previous monitor.
• The installation of this monitor obliges you to modify the position of the dip-switches on the back of the main
monitor. (fig.6-7-8-9 and chapter 5,e)
• An external call will be indicated on the monitors, with the possibility to answer with the unit of your choice (for
approx. 30 sec.)
6GB
CFI EXTEL ITOUCH SER.R1 - 05/2011 - V1