Assembly; Operation - Ryobi P713 Manual Del Operador

WARNING:
Do not use this product if it is not completely assembled
or if any parts appear to be missing or damaged. Use of
a product that is not properly and completely assembled
or with damaged or missing parts could result in serious
personal injury.
If any parts are damaged or missing, please call 1-800-525-2579 for assistance.
WARNING:
Do not allow familiarity with this product to make you
careless. Remember that a careless fraction of a second
is sufficient to inflict serious injury.
WARNING:
Always remove battery pack from the tool when you are
assembling parts, making adjustments, cleaning, or when
not in use. Removing battery pack will prevent accidental
starting that could cause serious personal injury.
WARNING:
Always wear eye protection with side shields marked to
comply with ANSI Z87.1, along with hearing protection.
Failure to do so could result in objects being thrown into
your eyes and other possible serious injuries.
WARNING:
Do not use any attachments or accessories not
recommended by the manufacturer of this product. The
use of attachments or accessories not recommended
can result in serious personal injury.
APPLICATIONS
You may use this product for the following purpose:
 Light-duty vacuuming of dry surfaces
INSTALLING/REMOVING BATTERY PACK
See Figure 1, page 6.
 Place the battery pack in the hand vac. Align the raised
rib on the battery pack with groove in hand vac's battery
port.
 Make sure the latches on each side of the battery pack
snap in place and that the battery pack is secured in the
hand vac before beginning operation.
 Locate the latches on the side of the battery pack and
depress both sides to release the battery pack from the
hand vac.

ASSEMBLY

WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.

OPERATION

STARTING/STOPPING THE VACUUM
See Figure 2, page 6.
 To start the vacuum: slide the switch toward the front
of the vacuum.
 To stop the vacuum: slide the switch toward the back
of the vacuum.
BRUSH/CREVICE ATTACHMENT
See Figures 3 - 5, page 6.
The combination brush/crevice attachment is stored on the
underside of the dust bowl.
To detach the brush/crevice attachment, pull it forward and
remove it from the dust bowl.
The cover of the brush/crevice attachment slides forward
to cover the brush so the attachment can be used as a
crevice tool.
 Turn off the vacuum.
 Remove the battery pack.
 Insert the attachment into the front end of the vacuum
dust bowl, making sure the attachment is firmly pushed
into place.
When purchasing replacement brush/crevice attachment,
request recommended part number 019484002007.
REMOVING/REATTACHING THE DUST BOWL
See Figure 6, page 6.
The dust bowl should be checked, emptied, and cleaned
periodically for maximum dust collection.
To remove:
 Remove the battery pack.
 Depress the release button located on top of the hand
vac. Pull the dust bowl down and out.
To reattach:
 Position the two sections as shown. Align the slot on the
bottom of dust bowl with the tab on the bottom of motor
housing, then snap the two sections together.
4 — English