Duplicating A Video Tape; Video Head Cleaning - Orion VR313A Manual De Instrucciones

DUPLICATING A VIDEO TAPE

If you connect the VCR to another VCR or camcorder,
you can duplicate a previously recorded tape.
Make all connections before turning on the power.
1
Load a blank cassette tape with the erase prevention
tab intact into the recording VCR.
Load a previously recorded tape into the playback
VCR or CAMCORDER.
2
Press the INPUT SELECT
button to select AUDIO/VIDEO
input position. "LINE" will
appear on the screen.
Playback VCR
To VIDEO OUT
AUDIO/VIDEO Cord (not supplied)
To VIDEO IN To AUDIO IN
Playback Camcorder
Recording VCR
To AUDIO IN
To VIDEO IN AUDIO/VIDEO Cord
For duplicating a previously recorded tape from a
camcorder, follow the camcorder manufacturer's
instructions. A typical camcorder dubbing hookup is
shown above.
22
4F70701B E P20-25
LINE
To AUDIO OUT
Recording VCR
To AV Jack
(not supplied)
22
3
Press the REC/OTR button on the recording VCR,
then press the PAUSE/STILL button.
4
Press the PLAY button on the playback VCR, then
press the PAUSE/STILL button.
5
Release the recording pause and the playback still
simultaneously to begin the duplicating process.
NOTES: • It is recommended that you set the SPEED to
the SP mode on the recording VCR for best
results.
• Unauthorized recording of copyrighted
television programs, films, video tapes and
other materials may infringe on the rights of
copyright owners and violate copyright laws.

VIDEO HEAD CLEANING

VIDEO HEAD CLOGGING
The video heads are the means by which the VCR
reads pictures from the tape during playback. In the
unlikely event that the heads become dirty enough to be
clogged, no picture will be played back. This can easily
be determined if, during playback of a known good tape,
there is good sound, but no picture (picture is extremely
snowy). If the heads require use a high quality head
cleaning system or have them cleaned professionally.
VIDEO HEAD CLEANING
Video head cleaning is needed when the playback
picture becomes unclear. This signifies that the heads
are getting dirty and can occur when playing poor quality
or damaged tapes. If the heads require cleaning use a
high quality head cleaning system or have them cleaned
professionally. If playing a head cleaning tape in the
VCR once does not improve the picture, play it several
times before requesting service.
DO NOT ATTEMPT TO CLEAN THE VIDEO HEADS
OR SERVICE THE UNIT BY REMOVING THE TOP
COVER.
NOTES: • Video heads may eventually wear out and
should be replaced when they fail to produce
clear pictures.
• To help prevent video head clogging, use
only good quality VHS tapes. Discard worn
out tapes.
7/2/03, 15:42