Tabla de contenido
Publicidad
FAMILIARISEZ-VOUS AVEC VOTRE ASPIRATEUR SANS
SAC VERTICAL
1.
Poignée
2.
Tige de verrouillage de la poignée
3.
Tube télescopique
4.
Boyau souple
5.
Brosse à meubles
6.
Suceur plat
7.
Bouton de relâche de la poignée
8.
Couvercle de la coupelle à
poussière
Spécifications techniques
Tension:
120 V, 60 Hz
Intensité:
12 A
*Avertissement: Les illustrations peuvent différer de l'appareil lui-même.
9.
Bouton de relâche de la coupelle
10. Coupelle à poussière (réservoir)
11. Phare
12. Sélecteur de hauteur de tapis
13. Bouton de relâche de la poignée
14. Bouton d'alimentation On/Off
15. Garde-meuble
16. Étrangleur
17. Porte-tuyau
26
TO ORDER REPLACEMENT SUPPLIES
BAGLESS UPRIGHT
TO ORDER REPLACEMENT FILTERS OR BELTS
for Model V1310-V1310C-V1310RS
Call:
1 (800) 798-9398
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
visit our website: www.sharkvac.com
FOR TECHNICAL SUPPORT
for Model V1310-V1310C-V1310RS
Call:
1 (800) 798-7398
Monday to Friday 8:30 A.M. - 5:00 P.M. Eastern Standard Time
Please Note:
Filter Ring and Pre-Motor Filters are washable. They should however be
replaced every three (3) months to ensure peak performance of your
vacuum.
The HEPA Dust Cup Filter may be washed. It should, however, be
replaced every three (3) to six (6) months, depending on amount of use, to
ensure peak performance of your vacuum. We recommend washing it
once a month or when suction appears to be reduced. To wash your HEPA
Dust Cup Filter, hold filter cartridge by frame flange and rinse under a tap
until all observable dirt has been removed. Some discoloration of the
HEPA filter material may occur, this is normal and will not affect the filter's
performance. When finished, shake off excess water. Do NOT wash in
dishwasher.
It is important that when you wash the HEPA dust cup filter, filter frame or
the pre-motor filters, you allow them to air dry COMPLETELY before using
again. We recommend 24 hours to air dry. DO NOT DRY IN DRYER.
Important:
Make sure that ALL washable Filters and HEPA Filter Frame are
completely dry before inserting back in the vacuum.
or
11
Publicidad
Tabla de contenido
