Audiovox CE710CR Manual Del Usuario página 7

IMPORTANT SAFETY INSTRUCTIONS
14. Refer all servicing to qualified service personnel. Servicing is required when the apparatus has been
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects
have fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate
normally, or has been dropped.
15. Wall and Ceiling Mounting - The appliance should be mounted to a wall or ceiling only as
recommended by the manufacturer.
16. Power Lines - An outdoor antenna should be located away from power lines.
17. Outdoor Antenna Grounding - If an outside antenna is connected to the receiver, be sure the antenna
system is grounded so as to provide some protection against voltage surges and built up static
charges. Section 810 of the National Electrical Code, ANSI/ NFPA No.70-1984, provides information
with respect to proper grounding of the mast and supporting structure, grounding of the lead-in wire to
an antenna discharge unit, size of grounding conductors, location of antenna discharge unit,
connection to grounding electrodes, and requirements for the grounding electrode. See figure 1.
S2898A NEC-NATIONAL ELECTRIC CODE
18. Object and Liquid Entry - Care should be taken so that objects do not fall and liquids are not spilled into
the enclosure through openings.
19. Power Sources - The appliance should be connected to a power supply only of the type described in
the operating instructions or as marked on the appliance. Do not overload wall outlet.
20. Servicing - The user should not attempt to se
operating instructions. All other servicing should be referred to qualified service personnel.
21. All markings are located on the exterior bottom enclosure of the apparatus.
22. CAUTION: Danger of explosion if battery is incorrectly replaced. Replace only with the same or
equivalent type.
23. The mains plug is used as the disconnect device from the mains.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE BLADE OF
PLUG TO WIDE SLOT. FULLY INSERT THE PLUG TO MAIN POWER
SOCKET. S2898A NEC-NATIONAL ELECTRIC CODE
FIGURE 1
EXAMPLE OF ANTENNA GROUNDING
AS PER NATIONAL
ELECTRICAL CODE
GROUND
CLAMP
ELECTRONIC
SERVICE
EQUIPMENT
rvice the appliance beyond that described in the
3
ANTENNA
LEAD IN
WIRE
ANTENNA
DISCHARGE UNIT
(NEC SECTION 810-20)
GROUNDING CONDUCTORS
(NEC SECTION 810-21)
GROUND CLAMP
POWER SERVICE GROUNDING
ELECTRODE SYSTEM
(NEC ART 250.PART H)