Adjusting The Angle On The Attachment - mbas Discman 4 Manual De Instrucciones

3
4

4.9.2 Adjusting the angle on the attachment

1
32
32
3)
4)
4
1)
The deviation of the angle setting can be up to 0.5°.
Check the grinding angle.
When grinding the base edge, clamp the ski tightly and make sure that
the Discman can slide freely (ski tightener, ski brake).
Attach the spring clip to the first ventilation slot on one side as shown
in the figure, then push the spring clip onto the other side until the
spring clip latches into place on the other side.
Push on the support plate as shown and fasten the screws.
The notch shows the support plate angle on the scale.
Make sure that the screws are fastened after completing
setting work.
Check the grinding results on disused skis or snowboards.
We accept no responsibility for operator error during
grinding!
Discman 2