Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
How to Assemble the Blades and Light Kit (continued)
5. Connect the 2-pin connector from the light socket
plate to 2-pin connector from motor assembly
(Figure 5).
CAUTION
To reduce the risk of electric shock, disconnect
the electrical supply circuit to the fan before
installing light kit.
Use only with light kits marked suitable for use in
Damp Locations.
6. Remove one of the three screws in the motor
housing. Slightly loosen the remaining two screws.
A
s s
e
m
b
e l
h t
e
g i l
t h
p
using the two key slots. Replace the third screw
and securely tighten all three screws (Figure 6).
7. Insert light bulbs into sockets (Figure 7).
8. Remove rubber washer and finial nut from post
on light socket plate. Postion glass onto Light
Socket Plate Post and secure with rubber washer
and finial nut. Do not over-tighten (Figure 8).
a l
e t
o l
w
r e
o t
h t
e
m
t o
r o
h
o
u
s
n i
g
LIGHT PLATE
LOWER ASSEMBLY
LIGHT SOCKET
GLASS
11
MOTOR ASSEMBLY
2-PIN CONNECTOR
LIGHT SOCKET 2-PIN
CONNECTOR
LIGHT PLATE LOWER
ASSEMBLY
Figure 5
MOTOR
HOUSING
SCREWS (3)
Figure 6
E27 15 WATT
Figure 7
RUBBER WASHER
FINIAL NUT
Figure 8
BULBS (2)
Publicidad
Capítulos
Tabla de contenido
Solución de problemas
