Section #1 - Fluval PROFILE 850 Manual De Instrucciones

6. Position the heater in the aquarium.
Refer to Section #3 of this Instruction Manual.
7. Decorate your aquarium with backgrounds, rocks and gravel.
Refer to Section #4 of this Instruction Manual.
8. Placing foreground plants in the aquarium.
Refer to Section #4 of this Instruction Manual.
9. Fill the aquarium with water up to half its height.
Refer to Section #4 of this Instruction Manual.
10. Place high plants in the aquarium.
Refer to Section #4 of this Instruction Manual.
11. Top up the aquarium up to aluminum aquarium frame.
Refer to Section #4 of this Instruction Manual.
12. Prepare the Strip-Light Canopy for start-up and place it on the aquarium top.
Refer to Section #5 of this Instruction Manual.
B. AQUARIUM START-UP
13. Plug in the External Filter.
Refer to Instruction Manual included within the filter box.
14. Plug in the heater.
Refer to Heater Instruction Manual on heater card.
15. Plug in the Strip-Light Canopy.
Refer to Section #5 of this Instruction Manual.
16. Add the fish after the aquarium has matured.
MAINTENANCE
For any maintenance operation for the aquarium glass and strip light canopy
Refer to Section #6 of this Instruction Manual.
For any maintenance operation for the aquarium filter or heater
Refer to instruction manual included with their packaging

SECTION #1

SETTING UP THE AQUARIUM CABINET – VERIFYING & INSTALLING THE GLASS TANK
-INSTALLING ALUMINUM POSTS
SET UP THE AQUARIUM CABINET
Do not attempt to set up the cabinet without reading and following the instruction manual.
The manual is included with the cabinet. If it is missing or unusable, contact
the store or Hagen Customer Service to get another copy.
The Fluval Aquarium must be placed on the appropriate Fluval cabinet
designed for that aquarium. Fluval cabinets are guaranteed to provide a
suitably solid and level surface that will not bend or warp. Using any other
form of support will invalidate your guarantee.
Never attempt to move or transport the Cabinet with the glass tank or any
other load on top of it.
Remove all contents from the box. Before you begin, identify, count and check
that you have all the parts needed for assembly. If any part is missing, do not
.
4