Lacor VITRO 69232 Instrucciones De Uso página 40

4.- The ceramic hob has 3 working modes. The device will start working with the power
programming mode by default. Press the SELECT button (6) to switch between the following
modes:
a.- Power selection mode: An LED will light up on the "POWER" function indicator (3)
when the appliance is working in this mode. The power levels that can be selected
POWER
are: 200 - 400 - 800 - 1000 - 1300 - 1600 - 1800 - 2000 W.
b.- Temperature selection mode: An LED will light up on the "TEMP" function
indicator (4) when the appliance is working in this mode. The temperature levels
TEMP.
that can be selected are: 60 - 160 - 240 - 320 - 400 - 480 - 520 - 600ᴼC.
c.- Keep warm mode: An LED will light up on the function indicator "WARM" (11) when
the appliance is working in this mode. The appliance will operate at a temperature
of 70ᴼC.
WARM
5.- To select the power or temperature level of the hob:
a.- Press the +/- buttons (7) to change the programming level until the display shows
the power or temperature at which you would like to cook.
b.- Use the power/temperature level scale (8) to directly select the power or
temperature level at which you want to cook. If you press the left part of the level
you will be selecting the lowest level of power or temperature. The more to the right
of the level you press, the higher the heating level of the hob will be.
6.- It is possible to time the cooking in any of the three operating modes available for the
appliance.
a.- Press the TIMER (5) button until the display shows the time for programming (image 2).
b.- The time by default is 00:00, select the time you want to program using the
+/- buttons. Each time you press one of the buttons, the time shown on the display
will increase/decrease by 1 minute. Press one of the +/- buttons continuously to
make the timer programming faster. In this way, the time increases or decreases in
10 minute jumps. The appliance can be programmed for a maximum of 240 minutes.
c.- Once you have finished programming the timer, wait until the display shows the
power/temperature programmed.
d.- Once the programmed time has elapsed; the appliance will stop heating and will
remain in STANDBY mode.
7.- Press the LOCK button (10) for three seconds to lock the selection buttons. This is how
changing the previously established programming by mistake can be avoided (Image 3).
8.- Press the LOCK button again for three seconds to enable the use of the appliance buttons
again.
9.- Press the ON/OFF button at any moment to stop the appliance working
The appliance will stop heating automatically and will remain in STANDBY mode.
Do not unplug the appliance while it is working. Press the ON/OFF button before
!
unplugging it from the mains electricity supply
10.- When the appliance is in STANDBY mode, the Word "HOT" will appear on the display to
indicate that the heating surface is at more than 60ºC (Image 4).
Do not touch or let leave anything on the heating surface if the Word "HOT" appears in
!
the display - it can be dangerous.
40