Nozzle Attachments; Assembly The Wall Holder; Charging The Rechargeable Battery; Using The Appliance - Profi Care PC-BS 3036 A Manual De Instrucciones

Nozzle Attachments

There are two different ways for connecting these nozzles
to the appliance:
Connection at the Hand Unit
• Note the guide lug on the crevice nozzle and on the
upholstery / brush nozzle. Hold the nozzles in such a way
that the guide lug points upwards.
• Plug one of the nozzles into the port on the handset. It
must engage audibly.
• To release the respective nozzle, press the release
button (10) while pulling it out at the same time.
• The special brush has neither a guide lug nor a release
button. You can simply attach this brush and remove it
again.
Connection to the Suction Pipe
At the lower end of the suction pipe, you will find the same
plug connection as on the handset. Mount / dismount the
nozzle as described above.
Crevice Nozzle
For vacuuming dirt from corners, joints and small gaps.
Combined Upholstery / Brush Nozzle
This nozzle is suitable for removing dust from smaller
surfaces such as upholstery, furniture or curtains. Use
the nozzle with locked brush to prevent scratching of the
surface to be cleaned.
• For this, press the button and push the brush to the end
of the nozzle. It must engage.
• Press the button again to unlock the brush.
Special Brush
This nozzle is especially good for gentle cleaning of larger
susceptible surfaces.

Assembly the Wall Holder

WARNING:
Make sure beforehand whether there are cables in the
wall which could be damaged!
CAUTION:
Place the wall holder so that the appliance is not exposed
to direct sunlight or other heat sources.
NOTE:
If you would like to simultaneously use the wall mount as
a charging station, there must be a power outlet nearby.
1. Measure the height for the wall holder. Hold the vacuum
cleaner against the wall with the suction pipe and the
floor nozzle installed.
2. Hold the wall bracket against the wall. Mark 2 drill holes.
3. Drill the holes and insert the wall plugs into the wall.
4. Insert the screws through the holes of the wall holder.
5. Tighten the screws with a screwdriver hand-tight.
PC-BS3036A_IM

Charging the Rechargeable Battery

CAUTION:
Do not charge the rechargeable battery unsupervised.
1. Turn off the appliance.
2. Connect the power adapter with the connection
socket (5).
3. Connect the power adapter to a certified wall socket.
Charge the appliance for approx. 5 hours before first-
time use.
NOTE:
• The indicator lights show the state of charge of the
rechargeable battery. (25 %, 50 %, 75 %, 100 %)
• The appliance has electronic charge control, which
prevents overcharging.
• Charging is completed when all 4 indicator lights
are lit.
• Once the appliance is disconnected from the power
adapter, the indicator lights go out.
• It is normal for the appliance to heat up during
charging.
4. Disconnect the power adapter from the outlet once the
rechargeable battery has been charged completely.
NOTE:
Even when switched off, the rechargeable battery dis-
charges continuously. If the appliance is out of use for a
longer period of time, charge the rechargeable battery at
least once every 4 to 6 weeks.

Using the Appliance

You can use the appliance as a floor vacuum cleaner or as
a handheld and upright vacuum cleaner (basic appliance).
1. Disconnect the appliance from the power adapter.
2. Turn on the appliance.
CAUTION:
• The suction opening must be free of blockages at all
times. Blockages will cause overheating and damage
to the motor.
• When the floor nozzle is blocked in such a way that
the brush roller can no longer rotate, the appliance will
switch itself off. The 4 indicator lights flash briefly. In
this case, remove the blockage as described in chapter
"Cleaning" "Floor nozzle". You may then continue
the operation.
NOTE:
• We recommend the higher power level for using the
appliance with the floor nozzle. The LED between the
buttons and ECO is off.
• During operation, depending on the charging capacity
of the rechargeable battery, 1 to 4 indicator are lit.
47
19.06.19