Chain Maintenance; General Inspection - SPARKY TV Serie Instrucciones De Uso

centre.
BAR TIP SPROCKET LUBRICATION
NOTE:
on the job.
Always clean the bar tip sprocket thoroughly prior opera
tion.
Use a lube gun (not included in the kit) to lubricate the
bar tip sprocket.
Insert needle nose into the lubrication hole D and inject
oil until it appears at outside edge of sprocket. (Fig.17)
by hand.
is lubricated entirely.
GUIDE BAR MAINTENANCE
saw with a chain this is too tight will contribute to rapid
bar maintenance is recommended.
CLEANING THE GUIDE BAR GROOVE
and chain. (Fig.18)
and locking knob.
OIL PASSAGES
Oil passages on the bar should be cleaned to ensure
proper lubrication of the bar and chain during operation.
eter.
NOTE: The condition of the oil passages can be easily
the chain saw. Your chain saw is equipped with an auto
matic oiler system.

CHAIN MAINTENANCE

WARNING:
against injury.
back chain.
12
EN
SHARPENING THE CHAIN
Chain sharpening requires special tools to ensure that
cutters are sharpened at the correct angle and depth.
that the saw chain be professionally sharpened in the
able from hardware stores.
The height difference between the tooth A and the ridge
B is the cutting depth. When sharpening the chain you
sional at the hardware store.
WARNING: The risk of kickback increases if:
Check if the chain is properly tensioned prior to start
sharpening.
Engage the chain brake to lock the chain on the bar.
depth.
width and length.
worn and should be replaced. (Fig. 19c)
STORAGE
When storing the machine in its original packaging the
oil tank must be completely emptied.
(with the oil tank cap facing upwards).
Clean the machine with a soft brush or dry cloth with
dren.
the guide bar and the chain and store them well lu
bricated.

GENERAL INSPECTION

Regularly inspect all fasteners and ensure they are
TV 1835 • TV 2040 • TV 2245
(Fig. 19a, 19b)
o
to the