has to be done by the manufacturer or his agent in order
BRUSH REPLACEMENT
must be replaced simultaneously with genuine brushes
CLEANING
tilation slots clean.
Regularly check to see if any dust or foreign matter has
accumulated dust. Wear safety glasses to protect your
eyes whilst cleaning.
Exterior plastic parts may be cleaned with a damp cloth
and mild detergent if necessary.
WARNING:
plastic parts.
WARNING:
tact with the tool.
IMPORTANT!
inspection and replacement) should be performed by
ine replacement parts.
Problem
Motor does not run.
Chain saw does not operate at full
capacity.
Poor cutting performance.
Original instructions
TROUBLESHOOTING
Probable cause
No supply power.
Worn carbon brushes.
Other electrical fault.
. Extension cord is too long or its cross
section is too small.
too low.
Improperly tensioned chain.
There is no oil in tank.
Oil passage clogged.
Warranty
The guarantee period for SPARKY power tools is deter
mined in the guarantee card.
dling will be excluded from the guarantee.
defects in workmanship will be corrected free of charge
through replacement or repair.
be recognized if the machine is sent back to the dealer
Notes
Carefully read the entire Original Instructions before us
ing this product.
tions without prior notice.
Corrective action
machine to another power outlet.
centre.
centre.
centre.
Use an extension cord with proper length and
cross section.
Connect the chain saw to another power
outlet.
Tension the chain properly.
Sharpen the chain or replace it.
Clean oil passage outlet.
Tension chain properly.
Sharpen the chain or replace it.
13
EN