Setting The Monitor; Setting The Video Source; Detecting The Trailer Camera - Dometic WAECO PerfectView Serie Instrucciones De Montaje

Using the LCD monitor
8.3

Setting the monitor

To set the monitor to suit your requirements, proceed as follows (fig. 0, page 6):
➤ Press the "
✓ The parameters to be set appear in the following order:
Page 1: Picture
– Brightness: 0 – 100
– Contrast: 0 – 100
– Colour: 0 – 100
– Volume: 0 – 100
– Auto Dim On, Off
Page 2: Options
– Language: German, English, French, Italian, Dutch, Spanish, Portuguese, Russian
– Camera 1/Camera 2/Camera 3: Normal or Mirrored
– Sensitivity: 1, 2
Setting of the switching threshold for the night dimmer function to avoid glare.
In dimming mode, the switching threshold can be set at two levels.
Page 3: Default
– Reset ("Default"): Default setting for all parameters
➤ Press the "+" button (3) or the "–" button (4) to set the required parameter.
➤ Press the "+" button (3) to increase the value of the selected parameter.
➤ Press the "–" button (4) to reduce the value of the selected parameter.
8.4

Setting the video source

Proceed as follows to set the video source (fig. 0, page 6):
➤ If you would like to switch to a different video source, press the "CAM" button (6).
✓ The monitor changes the camera in the order "Camera 1 – Camera 2 – Camera 3".
8.5

Detecting the trailer camera

This function is required when using a trailer camera (fig. c, page 7) if the system is
activated automatically via the reverse gear.
 One camera connected (e.g. vehicle without a trailer):
the camera connected to CAM1 (1) is activated.
 Two cameras connected (e.g. vehicle with a trailer):
the camera connected to CAM3 (2) is activated (CAM1 is inactive; CAM1 can only be
activated via the "CAM" button)
34
" button (5) to call up the required parameter.
PerfectView M55L, M75L
EN