Using The Lcd Monitor; Switching On The Monitor; Switching Off The Monitor - Dometic WAECO PerfectView Serie Instrucciones De Montaje

PerfectView M55L, M75L
This control cable is used as a signal cable for the activation of a side camera when an
indicator is flashing, for example.
➤ If necessary, connect the CAM1 socket (9) of the connection cable to the plug of the
video source 1 (e.g. side camera).
➤ If necessary, connect the CAM2 socket (10) of the connection cable to the plug of
video source 2 (e.g. camera).
I
NOTE
Observe the power consumption of the video system. The cameras are
equipped with heaters. A maximum current of 1.5 A can flow (three cameras in
heating mode). Use a disconnector switch for direct connection to the battery.
This allows you to disconnect the video system from the battery easily if you
are no longer using the vehicle.
Connection for a reversing camera
➤ If necessary, connect socket CAM3 (11) of the connection cable to the plug of the
additional reversing camera.
8

Using the LCD monitor

8.1

Switching on the monitor

➤ If the monitor is switched off, press the P button (fig. 0 2, page 6) to switch the
monitor on.
➤ The button lights up green.
✓ The picture appears.
8.2

Switching off the monitor

➤ Press the P button (fig. 0 2, page 6) to switch off the monitor.
➤ The button lights up red.
✓ The picture disappears.
EN
Using the LCD monitor
33