General Assembly; Safety - Kemper 1502199 Instrucciones De Montaje

1

General Assembly

1.1

Safety

Art. Nr.: 1502199
General Assembly
This manual describes the installation of the hinged cantilever for
the extraction arm 6.0 to 10 m. The complete hinged cantilever for
the extraction arm 6.0 to 10 m consists mainly of the swivel arm (1)
and the actual extraction arm (2). This manual describes the
assembly of the swing arm and the assembly of the actual
extraction arm onto the swivel arm. The instructions for the
assembly of the actual extraction arm can be found in the
extraction arm assembly instructions.
The operator must have experience in the assembly of the hinged
cantilever for the extraction arm 6.0 - 10 m. Use only trained or
instructed personnel for the hinged cantilever for the extraction arm
6.0 - 10 m. Clearly define the personnel's responsibilities that
pertain to assembly, installation and setup!
Changes of settings on the hinged cantilever for the extraction arm
6.0 to 10 m, may only be performed by specially trained personnel.
The assembly personnel must be informed or instructed on existing
laws, regulations and accident prevention regulations and available
safety devices on and around the hinged cantilever for the
extraction arm 6.0 - 10 m,
The assembly personnel must have understood the instructions
and it must be ensured that the instructions are observed.
Only this way it can be ensured that all personnel work in a safety
conscious and risk-aware manner.
1-1