Machine Setup - Nobles Anser 608681 Manual Del Operador

MACHINE SETUP

1. Unfasten two latches which hold recovery tank to
solution tank. Lift recovery tank off solution tank
(Figure 1).
FIG. 1
2. Pour up to 7.5 liters (2 gals) of hot water into
solution tank. Water temperature must not exceed
60°C (140°F). If you are only cleaning a small
spot, pour in less water. The label on solution tank
shows water level (Figure 2).
WARNING: Do Not Use Flammable Liquids Or
Operate Machine In Or Near Flammable Liquids,
Vapors Or Combustible Dusts.
This machine is not equipped with an explosion
proof motor. The electric motor will spark upon
start up and during operation which could cause a
flash fire or explosion if machine is used in an
area where flammable vapors/liquids or
combustible dusts are present.
FIG. 2
Anser (06–03)
Home Find... Go To..
3. If desired, add liquid cleaning solution to clean
water. See proper dilution as instructed on the
cleaning solution bottle.
FOR SAFETY: When using machine, follow
mixing and handling instructions on chemical
containers.
ATTENTION: Do not mix powdered chemicals in
solution tank. Mix powdered chemicals
thoroughly in a bucket before pouring into
machine. Powders are unlikely to dissolve
completely and can clog solution pump system.
4. Replace the recovery tank onto the solution tank
and fasten the two latches.
5. Plug power cord into a grounded power outlet
(Figure 3).
WARNING: Do Not Operate With Damaged
Power Cord. Do Not Modify Plug. Unplug Power
Cord Before Servicing Machine
If the supply cord is damaged or broken, it must
be replaced by the manufacturer or it's service
agent or a similarly qualified person in order to
avoid a hazard.
Grounded
3 Hole Outlet
Ground Pin
(120V)
FIG. 3
FOR SAFETY: Do not operate machine unless
cord is properly grounded.
FOR SAFETY: Do not operate machine with the
use of an extension cord.
OPERATION
Grounded Outlet
Grounding
Edge/hole
(220V/230V/240V)
5