General Safety Information - DT SWISS D 232 Manual De Instrucciones

Congratulations on the purchase of your new DT Swiss seat post! You have purchased a quality product
made by DT Swiss.
1. GENERAL INFORMATION
This user manual is intended for the user of the seat post. It includes information on the assembly,
adjustment, maintenance and care of the seat post, along with the provisions of the warranty.
For further information and activities refer to www.dtswiss.com.
Users must read and understand this manual before using the component. Third-party users must
also be informed about the following provisions. Keep this user manual handy / for reference in case
you need to refer to it later.
2. SAFETY

2.1 GENERAL SAFETY INFORMATION

DANGER
Incorrect handling, installation, maintenance or servicing can lead to accidents causing severe
injuries or death!
• Compliance with the following provisions is a prerequisite for accident-free use and faultless
performance.
• Assembly and maintenance of the seat post requires a basic knowledge of handling bicycle
components. If in any doubt, consult your retailer.
• The seat post should only be used in accordance with its intended use. Otherwise the user shall
assume responsibility.
• The seat post must be compatible with all parts of the bicycle.
• Before riding for the first time, the seat post must be checked for ease of action. In its lowest
position, the seat post must not collide with the seat post clamp or the seat tube of the bike
frame.
• The seat tube clamp, the seat tube of the bike frame and any reduction shim used must not have
sharp edges.
• Only use original DT Swiss accessories and spare parts.
• The seat post must not be changed or modified. The seat tube of the seat post must not be
shortened.
• The seat post must not be used if it is damaged or there are any signs of damage. If in any
doubt, consult your retailer.
2.2 COMPATIBILITY
The bike frame must be designed such that:
• A seat post with internal cable routing can be fitted.
• The seat post can be inserted at least 90 mm into the seat tube on the bike frame.
• The desired seat height can be adjusted without exceeding the maximum insertion depth of
190 mm or dropping below the minimum insertion depth of 90 mm.
Trailers, seat post racks or other add-on parts must not be attached to the seat post.
If a reduction shim is used, it must have a minimum length of 90 mm.
14